PCBRM_User_Manual_R9.pdf - 第32页

PCBRM15 & PCBRM System 5.2 User’s Manual Chapter 3: Set Up & Installation Part No. 4005.00.906 3-6 6. Loosen the rear two screws of each arm _ turn. 7. Turn the adjustment screw clockwise on both arms equally an …

PCBRM15 & PCBRM System 5.2 User’s Manual Chapter 3: Set Up & Installation

Part No. 4005.00.906 3-5

3. Place the board to be used in the process in to the

carrier arms. Align the site to be processed on the

board over the flow well and lock in place.

4. The board now will need to be leveled to match the

flow well. (step 2)

NOTE: The adjustment will be in the Y-axis only

not the X-axis

5. To adjust the board to match the flow well, loosen

the two front screws only on each arm two turns.

PCBRM15 & PCBRM System 5.2 User’s Manual Chapter 3: Set Up & Installation

Part No. 4005.00.906 3-6

6. Loosen the rear two screws of each arm _ turn.

7. Turn the adjustment screw clockwise on both arms

equally an 1/8 of a turn at a time until the level is at

the desired place.

8. Once level is achieved, bring the rear two screws

to bare only. Make a final adjustment as required

and bring the front screws to bare. Now snug up all

the screws – Do Not Over tighten.

PCBRM15 & PCBRM System 5.2 User’s Manual Chapter 3: Set Up & Installation

Part No. 4005.00.906 3-7

Compliant

(carrier) Arm

Lock Assembly

Carrier Arm

3.3 PCBRM System 5.2 - Carrier Arms Installation

• Loosen lock knob so compliant (carrier) arm lock assembly can straddle the x-axis rail.

• Place compliant arm lock assembly in place, as shown.

• Use mounting screws to mount carrier arm to bearing block.

Lock Knob

Bearing

Block

Mounting

Screw

X-Axis

Rail