00195166-0402_SM_D4_EN.pdf - 第99页

Service W ork Cutter Component Handling Service Manual SIPLACE D4 99 X Using the feeler gau ge, check the gap b etween tape deflector and movab le blade, over the entire length and width of the blade:  The 0.05 mm feele…

Service Work

Component Handling Cutter

98 Service Manual SIPLACE D4

X Apply Loctite no. 243 to the two M4 screws (7),

to fasten the joint in the moveable blade.

X Reinstall these screws, on the left and right, in

the movable blade.

NOTE:

Make certain that the midline / open-

end wrench surface of the articulated

joint is at right angles to the slide

surface of the movable blade (5, 6), so

that the articulated joint can slide

smoothly in the slot (= prevents turning)

of the movable blade .

X Use an SW 10 open-ended wrench to push

against the relevant articulated joint and

tighten both screws to the correct torque.

X Place the two new spacers to the left and right

of the moveable blade. The spacer side

marked with a number must face towards the

blade.

 The spacers and blades are matched !

4-32: Mounting new blades, mounting position of the blades, slide surfaces

to be greased

X Grease the contact / slide surfaces for the

movable blade exactly in the area shown (3).

 Do not lubricate the blades themselves.

X Place an adjustment plate (0.5 to 1.0 mm

thick) on the left and right, between the spacer

and the face of the movable blade.

X Place the holddowns previously removed back

on the new spacers.

 The version 03 holddowns match the version

04 cutters (= with tape deflector)!

Service Work

Cutter Component Handling

Service Manual SIPLACE D4

X Using the feeler gauge, check the gap between tape deflector and movable blade, over the entire

length and width of the blade:

 The 0.05 mm feeler gauge should fit through the gap.

 The 0.25 mm feeler gauge should not fit through the gap.

If the gap is not correct, check:

X Whether the wrong holddowns has been installed (with function status < 03).

The holddowns are those designed for cutters with function status -04 (= with tape deflector).

X Whether the blades, tape deflector etc. were cleaned before installation

If the gap is correct:

X Carefully fold the cover plate (with cover plate holders installed) back over the tape deflector.

X Reinstall the previously removed deflector

holder (= with tape deflector) and initially

tighten the 4 hexagon socket head screws (9)

hand-tight.

X Push the spacers (with inserted adjustment

plate) towards the movable blade - up to the

stop but not until they exert pressure against it,

otherwise it would no longer be possible to

remove the adjustment plates.

 The maximum permissible gap is 1.0 mm.

X In this position, tighten all 4 screws on the tape

deflector holders crosswise.

 Tighten the screws to the correct torque.

X Remove the two shim rings.

X Insert the new stationary blade in the correct

position ((see diagram) and screw tight (2

screws).

 Tighten the screws to the correct torque.

Service Work

Component Handling Cutter

100 Service Manual SIPLACE D4