80S-2080F480F5.pdf - 第504页
9 Maintenance SIPLACE 80 S-20/F4/F5 User Manual 9.3 Machine Base 05/99 Issue f rom Software Version SR.405.xx 9 - 38 9.3.8.3 Cleaning the protective covers Clean the protecti ve cover s with a soft, dry cl oth, if necess…
SIPLACE 80S-20/F4/F5 User Manual 9 Maintenance
05/99 Issue from Software Version SR.405.xx 9.3 Machine Base
9 - 37
9.3.8 Safety Hoods
9.3.8.1 Cleaning the Guideway
DANGER
Do not carry out any cleaning work with alcohol in the presence of naked lights or fire!
DANGER
Switch off the automatic placement systems at the main switch and disconnect from the power supply.
Use a vacuum cleaner nozzle to thoroughly clean the area of the two guideways along the long side of the
machine. Move the safety hood as required.
Clean the guide rails on both long sides of the side panel of the safety hoods with a brush dipped in alco-
hol.
Slide the safety hoods apart until you can see a gap in the guide rail between the safety hoods.
Apply a small quantity of Staburags N12 to this gap and move the safety hoods repeatedly back and forth
to spread the grease evenly.
If necessary, wipe over the safety hoods with a cloth soaked in alcohol.
9.3.8.2 Cleaning the Bar Code Strip
The position of the bar code strips on the machine is shown in Fig. 9.1.1, page 9 - 3.
Clean the bar code strips (used in connection with the supply of components) on the two side covers with
a soft dry cloth.
NOTE
The bar code strips are glued on. Do not use alcohol when cleaning. Otherwise the labels could come off.
9 Maintenance SIPLACE 80S-20/F4/F5 User Manual
9.3 Machine Base 05/99 Issue from Software Version SR.405.xx
9 - 38
9.3.8.3 Cleaning the protective covers
Clean the protective covers with a soft, dry cloth, if necessary.
Clean the protective covers with alcohol if they are very dirty.
CAUTION
• Do not use any cleaning agents other than water or ethyl alcohol to clean the protective covers.
• Only use soft cloths for cleaning.
Otherwise you will damage the EGB protective coating on the protective covers.
PLEASE NOTE:
Do not use alcohol to clean the barcode strips because they are glued on and could fall off.
SIPLACE 80S-20/F4/F5 User Manual 9 Maintenance
05/99 Issue from Software Version SR.405.xx 9.3 Machine Base
9 - 39
9.3.9 Empty Tape Cutter on SIPLACE 80F
5
Automatic Placement
Systems
9.3.9.1 Maintaining the Sliding Surface between the Moving Cutting Blade and
Retainer
DANGER
Switch off the automatic placement system and disconnect from the power supply.
WARNING
Disconnect the automatic placement system from the compressed air supply.
Spray the two sliding surfaces between moving cutting blade and retainer with the lubricant and corrosion
inhibiting agent WD40.
Fig. 9.3.8 Maintaining the sliding surfaces on the used tape cutter on SIPLACE 80F
5
automatic placement systems
- Key to Fig. 9.3.8
1 Moving blade
2 Retainer
A Spray the sliding surfaces with the lubricant and corrosion inhibiting agent WD40
2
A
2
A
1