80S-2080F480F5.pdf - 第567页
SIPLACE 80S-20/F4/F5 User M anual 9 Maintenance 05/99 Issue from Software Vers ion SR.405.xx 9.9 Camera S ystems and Coplanarity Laser Module 9 - 101 Fig. 9.9.1 Cleaning the illuminat ion head of the IC or F C camera - K…
9 Maintenance SIPLACE 80S-20/F4/F5 User Manual
9.9 Camera Systems and Coplanarity Laser Module 05/99 Issue from Software Version SR.405.xx
9 - 100
9.9.4.2 Cleaning the Glass Disk
Remove the glass disk for cleaning as follows:
The illumination head will already have been removed from the component camera (see Section 9.9.4.1).
Unscrew and remove the M2.5 hexagon socket screws from the glass holder. Pull the glass holder and the
glass disk with care diagonally downwards and out (see Fig. 9.9.1, Page 9 - 101).
Clean the glass disc with a dry, grease-free brush. Use a special cloth for cleaning optical equipment (e.g
Kodak) oder lens cleaning tissue (e.g. Kodak) to remove any fingerprints.
Fit the glass disk back in the reverse sequence and fasten the glass holder.
Place the illumination head back vertically on the component camera so that the fastening of the glass disk
points to the board conveyor. Make sure the illumination head has been pushed on as far as the stop.
SIPLACE 80S-20/F4/F5 User Manual 9 Maintenance
05/99 Issue from Software Version SR.405.xx 9.9 Camera Systems and Coplanarity Laser Module
9 - 101
Fig. 9.9.1 Cleaning the illumination head of the IC or FC camera
- Key to Fig. 9.9.1
1 Detail Y 2 Glass holder
3 Section X-X 4 Surfaces to be cleaned glass plate
5 Viewing IC illumination head
9 Maintenance SIPLACE 80S-20/F4/F5 User Manual
9.9 Camera Systems and Coplanarity Laser Module 05/99 Issue from Software Version SR.405.xx
9 - 102
- Sequence of work in Fig. 9.9.1
A Clean these surfaces on all sides (applies to IC camera only) and only if the glass disk is dirty.
B Unscrew and remove the hexagon socket screws.
C Pull the glass holder diagonally downwards and away.
D Clean this area.
9.9.5 Coplanarity Laser Module (SIPLACE 80F
4
or 80F
5
)
9.9.5.1 Safety Instructions
NOTE
Safety devices for operating the laser module in laser class 1:
The safety plug in the laser module will prevent the laser being operated outside the machine.
When one of the safety hoods is opened the operating voltage will be interrupted and the operating voltage
LED will go out at the laser module.
This safety feature will remain in force even when the key-operated switch has been operated (unlocked).
Switch off the machine at the main switch before carrying out maintenance work.
DANGER
The coplanarity laser module when without
safety devices corresponds to laser class 3B: the
laser works in a wavelength and power range
which is dangerous for eyes and skin.
Only when the safety features have not been
modified does the module correspond to laser
class 1 and can be operated without endanger-
ing others.
For this reason do not modify or tamper with the
safety devices.
m¦aa*dFd"F"=a"apm
pmpF¨zpFp*F"h
"F4d"
shh"¨:¬mh
"zFG¢Q_s|snn}