CM88Maintenace1.pdf - 第138页
Page 1-100 Changing the Consumable Parts Every 1500 to 6000 Hours 14 . Loosen the nut of rod end for the outlet of nozzle on cam BOX 1, with the 13mm spanner wrench. ∗ It is the first one viewed from the rear side. 15 . …
Page 1-99
REGULAR
MAINTENANCE
1
Changing the Consumable Parts Every 1500 to 6000 Hours
11. Set the main axis motor to 473 pulse
by hand.
12. Install the lever type dial gauge on the
linear of NC axis.
∗ Be careful not to damage the linear.
13. Install the lever type dial gauge to the
nozzle loosening lever.
• Set the lever type dial gauge to the right side of
the nozzle loosening lever horizontally.
3Y3C-E-MMD01-A09-01
3Y3C-116P
3Y3C-115P
Reverse rotation
3Y3C-113P
Right rotation
Page 1-100
Changing the Consumable Parts Every 1500 to 6000 Hours
14. Loosen the nut of rod end for the
outlet of nozzle on cam BOX 1, with
the 13mm spanner wrench.
∗ It is the first one viewed from the rear side.
15. Loosen the nut of rod end of nozzle
drawing part with the 13mm spanner
wrench.
16. Adjust the nozzle loosening lever to
the position shown below with a
10mm spanner wrench, and set the
dial gauge to 0.
3Y3C-E-MMD01-A09-01
To the next page
3Y3C-119P
3Y3C-118P
3Y3C-117P
3Y3C-164E
3
Returns(-) Extends(+)
Extends
(+)
Returns
(-)
Page 1-101
REGULAR
MAINTENANCE
1
Changing the Consumable Parts Every 1500 to 6000 Hours
17. Adjust the nozzle loosening lever so
that it comes into the gap of A (be-
tween nozzle numbers 1 and 2), rotat-
ing the head, and so that it is between
+ 0.05mm and 0.15mm head, turning
the wrench to the Extends (+) direc-
tion.
∗ If it is over the standard, the nozzle may not
work properly, or may be damaged.
18. Tighten the nuts of the rod end of
nozzle drawing part at the upper and
lower positions.
19. Check that the scale of dial gauge is
within the range of + 0.05mm to
0.15mm.
3Y3C-E-MMD01-A09-01
3Y3C-114P
Nozzle loosening lever
A
3Y3C-121P
+0.05mm
+0.15mm