CM88Maintenace1.pdf - 第62页
Page 1-24 Check Every 24 Hours (Routine) 1-3-6 Cleaning the Cutting Unit (after Operation) Clean the surroundings of cutting unit not to make it dirty . ∗ Before starting operation, carry out “Return to origin” in the “M…
Page 1-23
REGULAR
MAINTENANCE
1
Check Every 24 Hours (Routine)
1-3-5
Cleaning the Board Holder and X-Y Table (after Operation)
Clean the board holder and X-Y table.
1. Turn off the power.
2. Open the front safety cover.
Board holder
3. Clean the holder with a vacuum
cleaner.
∗ Clean to remove chips.
X-Y table
R
E
L
E
A
S
E
T
R
I
P
O
F
F
O
N
R
E
S
E
T
4G3C-AB01
15ULC0AA
07JHC2AA
3Y3C-E-MMD01-A03-02
Page 1-24
Check Every 24 Hours (Routine)
1-3-6 Cleaning the Cutting Unit (after Operation)
Clean the surroundings of cutting unit not to make it dirty.
∗ Before starting operation, carry out “Return to
origin” in the “Machine adjustment menu”
screen. If they have already been done, this is
unnecessary.
1. Turn off the power.
2. Open the rear center safety cover.
3. Clean the surroundings of cutting
unit.
∗ Check that there is no hard foreign bodies like
chips on the linear bearing rail or ball screws of
feeder drive axis.
R
E
L
E
A
S
E
T
R
I
P
O
F
F
O
N
R
E
S
E
T
Feeder drive axis
linear bearing rail
3Y3C-AI01
3Y3C-030P
3Y3C-083E
Cutting unit
Feeder drive axis
ball screw
3Y3C-E-MMD01-A03-00
Page 1-25
REGULAR
MAINTENANCE
1
3Y3C-E-MMD01-A03-00
Check Every 24 Hours (Routine)
1-3-7 Blower : Cleaning the Filter
Tape cut with the cutter is gathered to the blower. Cast off this and clean the filter in the blower.
1. Open the door of blower.
2. Take out case.
3. Cast off the waste tape.
4. Clean the inside of blower with
vacuum cleaners.
∗ Clean the filter.
Filter
1
2
3Y3C-028P
3Y3C-047P