CM88Maintenace1.pdf - 第98页

Page 1-60 Check Every 1000 Hours (Once T wo Months) 2 . Press Machine mainte . • The “Machine maintenance menu” screen appears. 3 . Press Head mainte . • The “Head mainte” screen appears. 4 . T urn off the servo switch. …

100%1 / 166
Page 1-59
REGULAR
MAINTENANCE
1
1-6 Check Every 1000 Hours (Once Two Months)
1-6-1 Transfer Head : Cleaning and Changing
This section describes cleaning and changing the transfer heads.
Operating procedure
1.Removing transfer head
2.Cleaning and checking transfer head (change)
3.Setting transfer head
4.Teaching head exchange
5.Checking machine parameter after teaching
NOTICE
Do not contaminate transfer head or reflector of nozzle with alcohol or lubricating
oil. It worsens the reflector early.
1. Removing the transfer head
Remove the nozzle and then the transfer head.
∗ Before starting operation, carry out “Return to
origin” on the “Machine adjustment menu”
screen. If they have already been done, this is
unnecessary.
1. Press
Machine
parameter
.
• The “Machine parameter menu” screen ap-
pears.
To the next page
3Y3C-E-MMD01-A06-03
Removing nozzle
Removing transfer head
Setting transfer head
Setting nozzle
Checking nozzle settings
Page 1-60
Check Every 1000 Hours (Once Two Months)
2. Press Machine mainte .
• The “Machine maintenance menu” screen
appears.
3. Press Head mainte .
• The “Head mainte” screen appears.
4. Turn off the servo switch.
5. Open the rear center safety cover.
6. Remove the nozzle holder.
“1-4-1 Cleaning and Changing the
Nozzles”
∗ Make sure of sorting nozzles for each type, not to set at wrong position.
3Y3C-EEn-MpMm-001
3Y3C-E-MMD01-A06-03
OFF ( )
ON ( )
SERVO
3Y3C-AI01
3Y3C-112P
1
2
3
4
5
3Y3C-133E
Rear side
Main axis
Height detection
head theta rotation
Chip pickup
Pickup angle head
theta rotation
3Y3C-132E
To the next page
Page 1-61
REGULAR
MAINTENANCE
1
Check Every 1000 Hours (Once Two Months)
7. Close the rear center safety cover.
8. Turn on the servo switch.
9. Press
UNLOCK
and Head rotate .
• 3 transfer heads on the pickup side of main
axis rotates by 180°.
10. Turn off the servo switch.
11. Open the rear center safety cover.
12. Remove other nozzle holders.
13. Remove the transfer head.
∗ Loosen the bolts (A) on the front of housing
with a hexagonal wrench.
OFF ( )
ON ( )
SERVO
3Y3C-AI01
3Y3C-048P
To the next page
Main axis
OFF ( )
ON ( )
SERVO
3Y3C-AG01
3Y3C-134E
3Y3C-E-MMD01-A06-02
Rear side
Main axis
3Y3C-135E
Rear side
1231C1AA
Bolt (A)