CM88Maintenace1.pdf - 第61页
Page 1-23 REGULAR MAINTENANCE 1 Check Every 24 Hours (Routine) 1-3-5 Cleaning the Board Holder and X-Y T able (after Operation) Clean the board holder and X-Y table. 1. T urn off the power . 2. Open the front safety cove…
Page 1-22
Check Every 24 Hours (Routine)
4. Turn off the servo switch.
5. Open the rear center safety cover.
6. Remove the foreign bodies from the
head with the air gun.
∗ Be careful not to leave the removed foreign
bodies on recognition lighting.
7. Close the rear center safety cover.
8. Turn on the servo switch.
9. Press
UNLOCK
and Main axis step .
• Main axis moves by steps.
10. After that, repeat the procedures 4 to
9 to remove the foreign bodies from
the transfer head.
OFF ( )
ON ( )
SERVO
3Y3C-AI01
Transfer head
3Y3C-029P
3Y3C-AG01
Rear side
Main axis
3Y3C-131E
OFF ( )
ON ( )
SERVO
3Y3C-E-MMD01-A03-01
Page 1-23
REGULAR
MAINTENANCE
1
Check Every 24 Hours (Routine)
1-3-5
Cleaning the Board Holder and X-Y Table (after Operation)
Clean the board holder and X-Y table.
1. Turn off the power.
2. Open the front safety cover.
Board holder
3. Clean the holder with a vacuum
cleaner.
∗ Clean to remove chips.
X-Y table
R
E
L
E
A
S
E
T
R
I
P
O
F
F
O
N
R
E
S
E
T
4G3C-AB01
15ULC0AA
07JHC2AA
3Y3C-E-MMD01-A03-02
Page 1-24
Check Every 24 Hours (Routine)
1-3-6 Cleaning the Cutting Unit (after Operation)
Clean the surroundings of cutting unit not to make it dirty.
∗ Before starting operation, carry out “Return to
origin” in the “Machine adjustment menu”
screen. If they have already been done, this is
unnecessary.
1. Turn off the power.
2. Open the rear center safety cover.
3. Clean the surroundings of cutting
unit.
∗ Check that there is no hard foreign bodies like
chips on the linear bearing rail or ball screws of
feeder drive axis.
R
E
L
E
A
S
E
T
R
I
P
O
F
F
O
N
R
E
S
E
T
Feeder drive axis
linear bearing rail
3Y3C-AI01
3Y3C-030P
3Y3C-083E
Cutting unit
Feeder drive axis
ball screw
3Y3C-E-MMD01-A03-00