CM88Maintenace1.pdf - 第56页

Page 1-18 Lubricating List of oil 3Y3C-055TE 3Y3C-E-MMD01-A02-00 . o N n o i t a c i r b u l f o s t r a P s e p y t l i O e m a n l i O s r e k a M 1 r a e r d n a t n o r f , e l b a t Y - X , r e d l o h d r a o B s i…

100%1 / 166
Page 1-17
REGULAR
MAINTENANCE
1
Lubricating
1-2-4 Greasing Point
NOTICE
Be careful not to leave grease on the belt, in greasing.
Remained grease worsens the belt early.
Main parts requiring lubrication
Linear bearing and ball screw
• For with a grease nipple, use the grease gun to fill grease.
• For without a grease nipple, apply grease to the rail.
This section describes lubrication of linear bearing as an example. Apply grease to the ball screw
alike.
1) Move the nipple to the other end.
• Remove any surplus grease with a cloth.
• Apply grease to the cleaning part.
∗ For the bearing with the opening for nipple, fill
grease through the nipple.
2) Move the sliding unit slowly for all
stroke several times.
Linear bearing Ball screw Bearing and cam follower
273C-IL087
Fill grease through nipple
3Y3C-E-MMD01-A02-00
Page 1-18
Lubricating
List of oil
3Y3C-055TE
3Y3C-E-MMD01-A02-00
.oN noitacirbulfostraP sepytliO emanliO srekaM
1
raerdnatnorf,elbatY-X,redlohdraoB
sixaevirdredeefdna,royevnoc
esaerG2AINABLA
LLEHSAWOHS
2
,regnahcelzzon,xobmac,sixaniaM
noitcestnuom,redeefepat
esaerG2UTNAILAV
3ecivedgnixednirofliOlioraeG022THOSEHTNYS
REBULKKON
4
daehrefsnarT
)gnir-Odna,gnikcapYM,gniraeb(
rofesaergeniroulF
muucav
V/LEIATREIRRAB
Page 1-19
REGULAR
MAINTENANCE
1
1-3 Check Every 24 Hours (Routine)
1-3-1 Checking the Vacuum Pressure (before Operation)
Check that the vacuum pressure is higher than - 93.3kPa with a pressure gauge.
∗ If any abnormal pressure is found, make
contact with the service department of us.
Make sure of the vacuum pressure
higher than - 93.3kPa
The figure viewed from the rear side with
the top cover of main body opened.
1-3-2
Checking for the Strange Noise (after Starting up and during Operation)
Check for the strange noise of X-Y table, front and rear conveyors, and feeder drive axis after
starting up and running machine.
Feeder drive axis
Rear conveyor
Front conveyor
X-Y table
3Y3C-027P
07JGC2AA00
4G3C-AB01
07JHC2AA
3Y3C-E-MMD01-A03-03
kPa
-20
-40-60
-80
-100
0