KE-750_MS.pdf - 第196页

4.8 Comment Select "1/Initial set-up" then "8/Comment..." and the revision (etc.) setting dialog will appear as follows. (1) Setting Items No. Item Contents 1 Serial No. Serial no. 2 Machine Revision …

100%1 / 257
4.7 XY Correction Coefficients
Select "1/Initial set-up" then "7/Correct coefficient of XY axis..." and the dialog will appear as follows.
(1) Setting Items
No. Item Contents
1 XY Correction Coefficients (XY) Separate correction coefficients for X & Y axes.
(2) Method of Setting
Enter X & Y separately directly from keyboard.
Select "Exit" and the following dialog will appear.
Select "OK" and XY correction coefficients set are reflected. After origin return and OCC
recognition of CAL block No. 1 mark, system exits.
Select "Cancel" to erase settings and exit.
2-28
4.8 Comment
Select "1/Initial set-up" then "8/Comment..." and the revision (etc.) setting dialog will appear as follows.
(1) Setting Items
No. Item Contents
1 Serial No. Serial no.
2 Machine Revision Machine revision report
3 Comments Comment report
(2) Method of Setting
– Enter values directly from keyboard.
2-29
4.9 OCC
4.9.1 OCC Offset
Select "2/Offset set-up" then "1/OCC", "1/OCC Offset" and the OCC offset setting dialog will appear
as follows.
(1) Setting Items
No. Item Contents
1 Scaling Size of 1 OCC pixel (mm/pixel)
2 Mark Center (Input Value) Mark pitch for scaling measurement (Spec value 3±0.001mm) (Temporary
parameter)
3 Assembling Angle Assembling angle of OCC body (in reference to main body) (° )
(2) Method of Setting
– Enter values directly from keyboard or follow operating directions to enter automatically.
– Select HOD device key to enter teaching.
– Use control menu to move head when it is in the way.
– Select "Exit" and after verification message box appears, home return will occur.
– Operating method of automatic input
Follow instructions to operate and values will automatically acquire.
c Scaling
Place camera adjustment jig onto near center of the CAL block.
Orient the camera adjustment jig under the bonding face so that the XY coordinates written on the
BOC are aligned so that the incoming direction is minus Y.
Then, place a single sheet of white paper between the camera adjustment jig and the CAL block.
Enter the marked distance of X & Y coordinates of the camera adjustment jig and CAL block. (Spec
value is 3 ｱ 0.001mm.)
2-30