KE-750_MS.pdf - 第87页
(7) As shown below, pass a dial gauge over the surf ace and adjust. When dial reads to within 0.5mm, tighten screw. (Camera and bracket may be set to any convenient height.) (8) Attach TLC lens (E3723700000) to CCD camer…
(3) Remove camera cable assemblies and M4 SEMS cap screws. Remove cameras from camera
brackets A & B.
(4) There are 4 hex screws each (M2 with spring & flat washers) holding cameras to VCS camera
brackets. Remove these screws.
(5) Turn switches on back of both cameras OFF and provisionally assemble with brackets following
step (4) in reverse sequence. (Switches are set at time of shipment, so only verification is required.)
0.3 VCS camera
bracket assy
0.4 VCS camera
bracket assy
VCS camera
bracket B
M4 SEMS cap
VCS camera bracket A
Fig. 8-1-2
1-79
(7) As shown below, pass a dial gauge over the surface and adjust. When dial reads to within 0.5mm,
tighten screw. (Camera and bracket may be set to any convenient height.)
(8) Attach TLC lens (E3723700000) to CCD camera. Leave the 4 focus adjust stop screws loose.
BedBed
Coat with
Locktite 242
A
llen head screw SM6020752TP
Spring washer WS0210002KN
Flat washer WP0220301SC
Careful with protrusion
(Thinner on lens side)
VCS camera
bracket B
CCD camera
A
llen head screw M2 x 7
SM6020752TP
Spring washer WS0210002KN
Flat washer WP0220301SC
VCS camera bracket A
Coat with Locktite 242
CCD camera
VCS 0.3 Assy (OPT)VCS 0.4 Assy (STD)
Fig. 8-1-3
1-80
(9) While pressing surface A to surface B, fasten bracket with M4 SEMS caps.
(10) Refer to Dia. 10 - 1 - 2 and connect camera cable assy to camera.
(11) Remount light base by following step (1) in reverse sequence.
E345272500
Base bridge (760)
E9617721000
CCD camera
E3715725000
VCS camera bracket B
SEMS cap screw (with
spring & flat washers)
(M4 x 14)
E3723700000
TLC lens
Optional
SEMS cap screw
(with spring & flat
washers)
(M4 x 14)
E3723700000
TLC lens
E9617721000
CCD camera
E3701725000
VCS camera bracket A
Fig. 8-1-4
1-81