KE-750_MS.pdf - 第92页
(3) Transfer cover glass to the new board. (Refer to section 10 - 4.) (4) Be careful with PWB connector orientation. A ssemble by following step (2) in reverse sequence. (5) Connect cables. (6) For information on adjusti…
3. 0.4/0.3 VCS Light PWB Assy Replacement
(1) Disconnect cable from PWB connector
(2) Loosen the 4 Allen head screws. Push so that spacers do not fall and remove diffuser.
(Refer to Dia. 10 - 1 - (1) if there are difficulties. Remove light base and continue.)
M3 SEMS
screw
Light base
Connecto
r
Space
r
0.3 VCS light PWB ass
y
A
llen head scre
w
Diffuse
r
0.4 VCS light PWB ass
y
Fig. 8-3-1
1-84
(3) Transfer cover glass to the new board. (Refer to section 10 - 4.)
(4) Be careful with PWB connector orientation. Assemble by following step (2) in reverse sequence.
(5) Connect cables.
(6) For information on adjusting brightness, refer to QA Table, Electricals, EL-11, 0.4 VCS / 0.3 VCS
Light Map.
1-85
4. BGA Light PCB Assy Replacement
(1) Remove BGA light cable assy connector from BGA/CSP relay cable assy.
(2) Grasp VCS diffuser A1 and pull upwards to remove.
(3) Remove the 4 truss screws holding diffuser cover.
(4) Remove the 4 plate screws and replace BGA light cable assy.
(5) Follow steps (1) ~ (4) in reverse sequence to reassemble.
VCS diffuser A1
E3706725000
Plate screw x 4
SM1030601SC
Note: Align BGA light PWB
with edge A and fasten.
Diffuser cove
r
E3709725000
Truss screw x 4
SM0030601sc
Note: Remove BGA ligh
t
PWB assy wire bundle from
VCS diffuser by pulling at
the separation section.
BGA ligh
t
support
BGA light PWB ass
y
VCS diffuser A1
BGA light cable ass
y
(BGA light PWB assy)
1-86