KE-750_MS.pdf - 第97页
1. Drive Cy linder Replacement (Refer to Dia. 9 - 1 - 1) (1) Turn main power source OFF. (2) Shut off main air supply (hand valve). (If the optional one-shot replacement base is us ed, disconnect and remove it from the m…
Chapter 9 Feeder Bank One-Shot Replacement (Optional)
(1) Air tube
(2) Connector
(2) Connector
(1) Air tube
Drive cylinder 20 Left
E26317210A0
Bank lifter
/
Lef
t
E2754721000
Driver bracke
t
E2633721000
Head
Driver bracke
t
support
Bank lifter / Right
E2755721000
Drive cylinder 20 Right
E26327210A0
Fig. 9-1-1
Driver bracket support A - Standard
E2634721000
Driver bracket support B - Optional (One-shot replacement base)
E2791721000
1-89
1. Drive Cylinder Replacement (Refer to Dia. 9 - 1 - 1)
(1) Turn main power source OFF.
(2) Shut off main air supply (hand valve).
(If the optional one-shot replacement base is used, disconnect and remove it from the main body.
Turn sensor and left / right roller lever ON. Raise bank lifter and shut off air.)
(3) Disconnect left / right air tubes (1) and connectors (2).
(4) Remove screws holding driver bracket support.
– For standard layout, driver bracket support A is attached through the bottom to the bottom of the
bank.
– For the one-shot replacement base, the driver bracket support B is attached through the top of
the bank lifter.
Driver bracket
support B
Drive cylinde
r
Driver bracket
support A
Bank lifte
r
Ban
k
(Standard) (One-shot replacement base)
Fig. 9-1-2
1-90
(5) Replace with new drive cylinder oriented upside-down as in Dia. 9 - 1 - 3.
Note: Work from the even surface of the table or the top of the bank.
– Mount so there is no gap between left & right cylinders (Dia. 9 - 1 - 3, Dia. 9 - 1 - 4).
– Mount so there is minimal gap between bank top surface and up/down cylinders (Dia. 9 - 1 - 5).
Fig. 9-1-3
Only replace left & right cylinders one at a time.
Previously mounted
cylinder
Bank top surface
No gap
No gap
Replaced cylinde
r
Fig. 9-1-4 Fig. 9-1-5
(6) Reassemble in reverse sequence.
1-91