Forte Max Manual.pdf - 第21页
ForteMAXDispensingSystemAddendum Installation an d Setup © 2023 Nordson Corporation 17 9. If the right dovetail is attached, loosen the dovetail m ounting screw and slide the dovetail assembly to the right (Figure 3-…
ForteMAXDispensingSystemAddendum Installation and Setup
16 © 2023 Nordson Corporation
8. Home the Forte MAX bracket.
a.
Auto Dual Simultaneous
1) Select the Maintenance button on the Navigation Panel.
2) Select Motion > Auto Dual Head Motion.
3) Select ADS Only (Figure 3-7).
Figure 3-7 Homing the Bracket – Dual Simultaneous
b.
Dual Action
1) Select the Maintenance button on the Navigation Panel.
2) Select Motion > Auto Dual Head Motion.
3) Click on Home in the Z-axis column (Figure 3-8).
Figure 3-8 Homing the Bracket – Dual Toggle
?
NOTE
Homing the Forte MAX bracket should be the first step performed each time the valve
pitch is changed.
ForteMAXDispensingSystemAddendum Installation and Setup
© 2023 Nordson Corporation 17
9. If the right dovetail is attached, loosen the dovetail mounting screw and slide the dovetail
assembly to the right (Figure 3-9).
> The slide bracket in Figure 3-9 is shown in Position 3 as indicated by the position of the
lower right screw below #3 on the slide bracket.
Item Description
1 Dovetail Mounting Screw
2 Right Dovetail Assembly
3 Standard Slide Bracket
Figure 3-9 Removing the Right Dovetail
10. Remove the four (4) screws securing the slide bracket to the dispense head and adjust the
bracket position as necessary (Figure 3-10).
Figure 3-10 Remove Slide Bracket Mounting Screws
1
2
3
ForteMAXDispensingSystemAddendum Installation and Setup
18 © 2023 Nordson Corporation
11. Install the slide bracket in the desired position and loosely tighten the screws (Figure 3-11).
> The standard slide bracket will be installed in Position 0 because the valve pitch is
50 mm (Table 3-1).
Figure 3-11 Installing the Slide Bracket
12. While applying a slight downward pressure on the slide bracket so that it is resting, and in
alignment with the alignment length in the back, torque the four (4) screws to 1.3 Nm
(12 in-lbs).
> Figure 3-12 and Figure 3-13 show the slide bracket in Position 0 and Position 3.
> As stated in 3.5 Slide Bracket Positions, the slide bracket position depends on the valve
pitch range (
Figure 3-3 and Figure 3-4).
Figure
3
-
12
S
l
i
d
e
B
r
a
c
k
e
t
i
n
P
o
s
i
t
i
o
n
0
Fi
g
ure
3
-
13
S
l
i
d
e
B
r
a
c
k
e
t
i
n
P
o
s
i
t
i
o
n
3