Forte Max Manual.pdf - 第40页
ForteMAXDispensingSystemAddendum Recipe Creation 36 © 2023 Nordson Corpo ration 4.4.2 Creating a Recipe for a Panel with an Od d Number of Columns The following panel board (Figure 4-2 1) is used as an example in the…
ForteMAXDispensingSystemAddendum Recipe Creation
© 2023 Nordson Corporation 35
12. If desired, duplicate the container by performing the following steps:
a.
Right click on the "Do Rectangle" instruction and select Copy.
b.
Right click on the "Do Rectangle" instruction again and select Paste.
c.
Repeat Step 12b two more times until there are four "Do Rectangle" instructions.
> After you have pasted the instructions, you need to edit the starting point for the
additional containers.
d.
Select the first duplicated instruction and click on .
> The Place Container Setup window opens (Figure 4-15).
e.
Move the camera crosshairs to the container starting point and click on Teach.
f.
Click on Done when finished.
g.
Repeat Step 12d through Step 12f for the remaining containers.
> Make sure to add a height sense instruction prior to the dispense instructions. This
can be done in the Workpiece pattern or the dispense pattern.
13. When finished, there will be four "Do (Container Name)" instructions in the Recipe Tree
(Figure 4-19).
Figure 4-19 Do Container Instructions
> All four containers have been placed (Figure 4-20).
1 2 3 4 5 6 7 8 9 10 11 12
2
1
6130139 REV 1
STRAIGHT
B,1
B,2
2,1 2,2 2,3 2,4 2,5 2,6
1,1 1,2 1,3 1,4 1,5 1,6
4,1 4,2 4,3 4,4 4,5 4,6
A2
A1
3,1 3,2 3,3 3,4 3,5 3,6
A2
A1
4
3
4,1 4,2 4,3 4,4 4,5 4,6
A2
A1
3,1 3,2 3,3 3,4 3,5 3,6
A2
A1
2,1 2,2 2,3 2,4 2,5 2,6
1,1 1,2 1,3 1,4 1,5 1,6
Figure 4-20 Containers Placed
ForteMAXDispensingSystemAddendum Recipe Creation
36 © 2023 Nordson Corporation
4.4.2 Creating a Recipe for a Panel with an Odd Number of Columns
The following panel board (Figure 4-21) is used as an example in the following instructions: 3 x 7 carrier
with 40 mm part pitch.
Figure 4-21 Board with an Odd Number of Columns
The application requirement is to cover the red components on each part (Figure 4-22).
Figure 4-22 Application Requirement
There are three dispensing options (Figure 4-23 through Figure 4-25):
Figure 4-23 Dispensing Option 1
ForteMAXDispensingSystemAddendum Recipe Creation
© 2023 Nordson Corporation 37
Figure 4-24 Dispensing Option 2
Figure 4-25 Dispensing Option 3
Based on the layout design guidelines described in 3.4 Designing the Dispense Layout, Option 2 is the
best option. Option 1 and Option 3 are not in the 45 mm to 112 mm valve pitch range (Table 3-1).