Forte Max Manual.pdf - 第42页
ForteMAXDispensingSystemAddendum Recipe Creation 38 © 2023 Nordson Corpo ration To create the program: ? NOTE If necessary, refer to 4.4.1 Crea ting a R ecipe for a Multi-up Panel for detailed instructions on creatin…
ForteMAXDispensingSystemAddendum Recipe Creation
© 2023 Nordson Corporation 37
Figure 4-24 Dispensing Option 2
Figure 4-25 Dispensing Option 3
Based on the layout design guidelines described in 3.4 Designing the Dispense Layout, Option 2 is the
best option. Option 1 and Option 3 are not in the 45 mm to 112 mm valve pitch range (Table 3-1).
ForteMAXDispensingSystemAddendum Recipe Creation
38 © 2023 Nordson Corporation
To create the program:
?
NOTE
If necessary, refer to 4.4.1 Creating a Recipe for a Multi-up Panel for detailed instructions
on creating the recipe, pattern, and container.
1. Create a recipe and teach the workpiece fiducials.
2. Create the pattern, teach the pattern fiducials, and add dispensing instructions.
3. Create a container and define the container dimensions, origin and column and row pitch
ends (Figure 4-25).
4. Perform the following steps to place the container.
a.
Select the Workpiece pattern in the Recipe Tree and select Place Container .
b.
Select the Container to Place, Starting Corner, and Dispense Mode (Figure 4-27).
> In this example we are going to select Lower Left and Serpentine by Columns
(Figure 4-28). This will minimize the dispense head motion and therefore speed up
the program.
Figure 4-27 Place the Container
Figure
4
-
26
D
e
f
i
n
e
C
o
n
t
a
i
n
e
r
S
e
t
t
i
n
g
s
ForteMAXDispensingSystemAddendum Recipe Creation
© 2023 Nordson Corporation 39
Figure 4-28 Serpentine by Columns
c.
Click on Next.
d.
Select Simultaneous and Enable Real Time Correction (Figure 4-29).
> The Head 1 (blue) and Head 2 (green) boxes indicate Valve 1 and Valve 2
dispense locations and should appear as shown in Figure 4-29).
Figure 4-29 Dual Head Setup
e.
Click on Done.
> A Do "Container Name" instruction will appear in the Recipe Tree.