DFD6361-Maintenance.pdf - 第480页
E-44 3. Maintenance to Be Performed at 7-Day (Recommended) Intervals Summary of this sectio n This section describes the m aintenance to be done at 7-da y intervals. Section No. Titl e Contents 3-1 Cleaning the Cutting R…
E-43
2-2. Maintenance and Inspection
After Turning ON the Power
Maintenance and inspection after turning ON the machine power
Perform the following inspection everyday after turning ON the machine
power.
1 Check the air supply pressure.
- Perform the steps stated in section B-1, [Starting up the Machine]
of the Operation Manual.
2 When the spindle is turning, does it produce any abnormal noise or
vibration?
3 Neither the splash cover nor arm section cover open during spindle
rotation.
4 Neither the splash cover nor arm section cover open during spinner
table rotation.
5 The Z-axis ascends to escape when the Z EM sequence is initiated.
6 Activate the EMO switch to check whether the Z-axis ascends to
the upper limit, the spindles stop rotating and the power supply
shuts off.
7 The pressure gauge of high-pressure pump reads a specified level.
E-44
3. Maintenance to Be Performed at 7-Day
(Recommended) Intervals
Summary of this section
This section describes the maintenance to be done at 7-day intervals.
Section No. Title Contents
3-1 Cleaning the Cutting
Room
- Procedures for cleaning the
cutting room
E-45
3-1. Cleaning the Cutting Room
Operation flow
This section describes the procedures for cleaning the cutting room, including
cleaning of outer area and inside of the water case.
The procedure for cleaning the cutting room consists of the following steps.
3-1-1 Cleaning the water case exterior
3-1-2 Cleaning the water case interior
Safety items for cleaning the cutting room
WARNING
If any touch panel control is inadvertently activated during
maintenance or inspection, unexpected machine operation may
cause death or serious injury.
While you don't use the touch panel, press the Disco's logo button
located at the upper left of the screen in order to lock up and
deactivate the touch panel.
NOTICE
Neither safety goggles, protective gloves, stepstools, flashlights nor
alcohol, all of which are necessary for maintenance work, are not
supplied with the machine. Use what are furnished in your factory or
what comply with your factory's standards.