DFD6361-Maintenance.pdf - 第550页
E-114 Before g reasing Have on hand the following tools before starting greasin g. For the MSDS; See the section G-2, [Mater ial Safe t y Data Sheet (MSDS) ]. Grease Name AFC gre ase Maker THK Part No. MOELJ007 Grease gu…
E-113
6-6. Greasing the θ-axis Sensor Assembly Section
Operation flow
The procedure for greasing the rail of θ-axis sensor assembly linear guide
section consists of the following steps.
6-6-1 Preparation of greasing the θ-axis sensor assembly section
6-6-2 Greasing the θ-axis sensor assembly section
6-6-3 Completion of greasing the θ-axis sensor assembly section
Safety items for greasing the rail of θ-axis sensor assembly
WARNING
If any touch panel control is inadvertently activated during
maintenance or inspection, unexpected machine operation may
cause death or serious injury.
While you don't use the touch panel, press the Disco's logo button
located at the upper left of the screen in order to lock up and
deactivate the touch panel.
CAUTION
If the axis does not move for a long time after being greased, the
grease will harden. This could adversely affect the precision of the
machine, such as a position error during axis operation.
Do not perform greasing before a long-term operation suspension.
NOTICE
- If the areas to be lubricated are dark due to the environmental
conditions, confirm the nipple locations and cleaning areas with a
flashlight or the like to ensure proper lubrication.
- Neither safety goggles, protective gloves, stepstools, flashlights nor
alcohol, all of which are necessary for maintenance work, are not
supplied with the machine. Use what are furnished in your factory or
what comply with your factory's standards.
E-114
Before greasing
Have on hand the following tools before starting greasing.
For the MSDS;
See the section G-2, [Material Safety Data Sheet (MSDS)].
Grease Name AFC grease
Maker THK
Part No. MOELJ007
Grease gun unit Name MG-70
Maker THK
Part No. MOELJ006
Lint-free waste
Spatula (resin)
Flashlight
Protective gloves
3mm Allen wrench
Phillips screwdriver
E-115
6-6-1. Preparation of greasing the θ-axis sensor assembly
section
Procedures for preparation of greasing the θ-axis sensor assembly section
Step No. Do This
1
Press the <System Initial> button to effect the system
initialization.
2
With the button, move the X-axis to the left to
remove the bellows located at the right side of X-axis.
3
Turn OFF the main switch and remove the key.
4
Turn OFF the circuit breaker on the left of the machine. Lock out
the circuit breaker lever with a padlock or the like.
5
Shut off the facility power supply.
Continued in the next section.