DFD6361-Maintenance.pdf - 第571页
F-1 F. CONSUMABLE PARTS REPLACEMENT Cont ents of t his ch apter This chapter d escribes co nsumable parts repl acement b y their replacement i ntervals. Section No. Titl e Contents Replacin g the air clean u nit consumab…
E-134
6-8-5. Completion of greasing the Z-axis
Procedures for completion of greasing the Z-axis
Step No. Do This
(Continued from the previous section)
1
Turn ON the facility power source.
2
Open the circuit breaker lever lockout and then turn ON the
circuit breaker.
3
Insert the key into the main switch and then turn ON the main
switch.
4
Press the <System Initial> button to effect system initialization.
5
On the AXIS OPERATION screen [screen 7.2], shuttle the Z1-
and Z2-axis between the upper and lower end at least three times
to apply the grease uniformly to the entire axis.
F-1
F. CONSUMABLE PARTS REPLACEMENT
Contents of this chapter
This chapter describes consumable parts replacement by their replacement intervals.
Section
No.
Title Contents
Replacing the air clean unit consumable
part
Replacing the halogen lamp
Replacing the microscope LED light
(Contact your nearest Disco Service
Office.)
Replacing the spindle carbon brush
Replacing the spray tip of the spinner
section
Replacing the pad of the upper arm section
Replacing the pad of the lower arm section
1
Consumables to Be Replaced at
365-Day Intervals
(Recommended)
Replacing the spinner section roll cover
Replacing the spindle coolant water flow
rate sensor
2
Consumables to Be Replaced at
700-Day Intervals
(Recommended)
Replacing the solenoid valve
Replacing the bellows
Replacing the waterproof cover of θ-axis
Replacing the O-ring for θ-axis
Replacing the V-ring for θ-axis
Replacing the chuck table center ring
3
Consumables to Be Replaced at
1000-Day Intervals
(Recommended)
Replacing the spinner table O-ring
Replacing the flowmeter
4
Consumables to Be Replaced at
1800-Day Intervals
(Recommended)
Replacing the hard disk drive
(Contact your nearest Disco Service
Office.)
Replacing the spinner high- pressure pump
consumable part
Replacing the fluorescent lamp
Replacing the UV irradiation lamp
Replacing the controller of the wheel
coolant water
5
Consumables Whose
Replacement
Intervals Differ
Depending on the Machine Use
Conditions
Replacing the circuit board of the
electrical system due to life end of its
battery
(Contact your nearest Disco Service
Office.)
F-2
1. Consumables to Be Replaced at 365-Day
(Recommended) Intervals
Summary of this section
This section describes consumables to be replaced at 365-day intervals.
Section No. Title Contents
1-1 Replacing the Air Clean
Unit Consumable Parts
- Procedures for replacing the mist
separator element
- Procedures for replacing the air
filter
1-2 Replacing the Halogen
Lamp
- Procedures for replacing the
halogen lamp
1-3 Replacing the Microscope
LED Light
- Procedures for replacing the
microscope LED light
1-4 Replacing the Spindle
Carbon Brush
- Procedures for replacing the
spindle carbon brush
1-5 Replacing the Spray Tip
of the Spinner Section
- Procedures for replacing the
spray tip of the spinner section
1-6 Replacing the Pad of the
Upper Arm Section
- Procedures for replacing the pad
of the upper arm section
1-7 Replacing the Pad of the
Lower Arm Section
- Procedures for replacing the pad
of the lower arm section
1-8 Replacing the Spinner
Section Roll Cover
- Procedures for replacing the
spinner section roll cover