DFD6361-Maintenance.pdf - 第617页
F-47 Procedur es for prep aration of re placing th e Y-ax is section roll c over (C ontinued) Step No. Do This 8 Remove the cover [A]. [P] [A] FRONT SIDE 9 Open the cover [P ]. - For the opening proced ures of the touch …
F-46
Procedures for preparation of replacing the Y-axis section roll cover (Continued)
Step No. Do This
7 [When there is maintenance space provided at the rear
side of the machine]
Remove the cover [R].
[R]
REAR SIDE
[When there is no maintenance space provided at the rear
side of the machine]
Go to the step No. 8.
F-47
Procedures for preparation of replacing the Y-axis section roll cover (Continued)
Step No. Do This
8
Remove the cover [A].
[P]
[A]
FRONT SIDE
9
Open the cover [P].
- For the opening procedures of the touch panel section outer
cover
See section A-1, [Machine Outer Cover].
10
Remove the partition (left). Then store it sufficiently away from
the working area.
- For the removal procedures of the partition (left);
See the section 1-2-3-2 of this chapter, [Removing the partition
(left)].
11
Store the removed covers and partition sufficiently away from
the working area.
Continued in the next section.
F-48
1-8-2. Replacing the Y-axis section roll cover
Procedures for replacing the Y-axis section roll cover
Step No. Do This
(Continued from the previous section.)
1
Open the splash cover.
2
Loose four retaining screws (M3) of the roll cover at the center of
the Y-axis section. Do not remove them.
Retaining screws (M3)
Roll cover
3
Replace the roll cover with the new one.
- You can mount the center roll cover in any direction.
Name Part No.
Sheet bellows MOKFY016
4
Firmly screw down four retaining screws (M3).