Infinity EX Transportation.pdf - 第14页
INFINITY EX TRANSPORT ATION MAJOR RE LOCATION 31.1 4 Technical Reference Manual Chapter Issue 3 Jan 04 Figur e 31-6 Fron t T ransit Bracket Stud Locations NO TE Item numbering above is the sa me for items listed on the T…
INFINITY
EX
TRANSPORTATION
MAJOR RELOCATION
Chapter Issue 3 Jan 04 Technical Reference Manual 31.13
2. Position the smaller end of the restrainer bracket so that its recess fits snugly
on the chase striker plate.
3. Using an Allen key, extend the restrainer slowly until the actuator no longer
makes contact with the striker plate (approx. 6mm gap).
4. Tighten the restrainer bracket locknut.
5. Visually check that the actuator is clear of the striker plate.
Linear Bearings Lightly grease the following THK linear bearings using LM grease Pt No
120011:
• Print Carriage (in 2 positions) - Top of printhead casting
• Y Axis (in 2 positions) - Underside of rail supports on both sides of the
machine running from front to rear
• Rising Table (in 2 positions) - Either side of table casting at rear of machine
• X Axis - Front of camera X rail
• Screen Rail Adjustment (in 2 positions) - At rear of chase either side
INFINITY
EX
TRANSPORTATION
MAJOR RELOCATION
31.14 Technical Reference Manual Chapter Issue 3 Jan 04
Figure 31-6 Front Transit Bracket Stud Locations
NOTE
Item numbering above is the same for items listed on the Transit Brackets
Machine Location figure and table.
Item Description
1 Front Transit Bracket
1a Screen Chase Studs (2 positions)
1b Print Carriage Studs (2 positions)
1c Printhead Lift Studs (2 positions)
1e Squeegee Mount Support Bracket
1f Camera Carriage Fixing Screw
3 Paste Dispense Transit Bracket
7 Printhead Safety Prop
1
1a
1c
1b
1a
1c
1b
1f
3
Front View of Machine (Covers Removed)
1e
FRONT
FRONT
INFINITY
EX
TRANSPORTATION
MAJOR RELOCATION
Chapter Issue 3 Jan 04 Technical Reference Manual 31.15
Dismantling To ensure the machine is not damaged during transportation it is recommended
that certain components are removed before dispatch. Remove the following
components:
• Paste dispenser nozzle
• Paste cartridge sleeve
• Paste dispenser drip tray
• Squeegees or ProFlow
• MMI assembly and arm
• Tricolour beacon
• Pneumatic supply fitting
• Magnetic tooling pins
• TCU manifold
• Auxiliary Conveyors (HTC option)
Removal of the
Auxiliary Conveyors
(HTC Option)
To remove the right hand auxiliary conveyor from the machine carry out the
following procedure:
1. Raise the head and insert the head prop.
2. Power down the machine and disconnect the quick release pneumatic con-
nection at the machine’s external services panel.
3. Remove the six pan head M4 securing screws and washers from the front
right hand safety cover and remove the cover from the machine.
4. Remove the six pan head M4 securing screws and washers from the rear right
hand safety cover and remove the safety cover from the machine.
5. Remove the two countersunk M5 screws securing the right hand safety plate
to the green wear insert fitted to the top of the right hand conveyor.
6. Carefully lift the safety plate clear of the machine and remove the two plastic
safety cover spacers from the on top of the green wear insert.
View on Right Hand Side of Machine
M4 Pan Head Screws
(in 6 positions)
Safety Cover
(in 2 positions)
Safety Plate
M5 Countersunk Screw
(in 2 positions)