Infinity EX Transportation.pdf - 第29页

INFINITY EX TRANS PORTATION MAJOR RELO CATION Chapter Issue 3 J an 04 Technical Reference Manual 31.29 with the end stop pin. 7. Fit the k eyboard to the k eyboard tray , ensure the keyboard is secured to the tray with t…

INFINITY

TRANSPORTATION

MAJOR RELOCATION

31.28 Technical Reference Manual Chapter Issue 3 Jan 04

quick release fasteners. Unplug the E Stop connector from the back of the

corner panel and disconnect the System button at plug 8PL14. Release the

ESD cable by pulling the cable spade connector from the capacitor fixing

point. Remove the access panel from the machine.

2. Fit the large friction washer to the MMI support bracket so that the dowel

fits through the washer locating hole, (graphic below refers).

3. Locate the MMI arm onto the pivot post of the machine MMI arm support

bracket. Ensure the MMI arm locates onto the bracket dowel correctly so

that arm travel is restricted to an approximate 90

arc of movement.

4. Fit the smaller friction washer, large stainless steel spacer, M12 plain washer

and M12 nyloc nut to the mounting bracket pivot post, (graphic below

refers). Tighten the nut until the MMI arm offers resistance when moved.

5. Slide the machine right hand corner access panel over the MMI arm.

6. Fit the MMI assembly, tube and keyboard tray to the MMI tube and secure

Friction Washer

Locating Dowel

MMI Mounting Pivot Post

Friction Washer

Spacer

INFINITY

TRANSPORTATION

MAJOR RELOCATION

Chapter Issue 3 Jan 04 Technical Reference Manual 31.29

with the end stop pin.

7. Fit the keyboard to the keyboard tray, ensure the keyboard is secured to the

tray with the velcro hook and eye strips.

8. Utilizing the slot in the cable conduit, feed the following cables through the

conduit:

• Infrared Receiver/Transmitter

• Monitor Power Supply (M16SK03)

• VGA Cable (M16PL02)

• Touchscreen Cable (M16PL01)

• Keyboard Cable

NOTE

For ease of installation, straighten the keyboard cable before feeding through

the cable conduit.

9. Carefully feed the two button control cable from the rear of the MMI tube

through the cable conduit. Ensure the heatshrink protection on the cable

End Stop Pin

INFINITY

TRANSPORTATION

MAJOR RELOCATION

31.30 Technical Reference Manual Chapter Issue 3 Jan 04

assembly is located in the slot of the MMI tube.

10.Utilizing the three pipe clamps, clip the cable conduit to the rear of the MMI

tube.

11.Secure the infrared transmitter/receiver beneath the touchscreen using the

velcro hook and eye strips.

12.Connect the cables to the following connections on the rear of the monitor:

• Monitor Power Cable - Power DC-IN

• VGA Cable - Display Input

• Touchscreen Cable - Touch RS-232

13.Gain access to bracket (Pt No 156875) located on the right hand side of the

lower frame.

14.Connect the cables from the MMI to the following connectors fitted to the

bracket:

• Two Button Control (14PL08) - 14SK08

• Infrared Transmitter/Receiver (14SK29) - 14PL29

• VGA Cable (14SK04) - 14PL04