Infinity EX Transportation.pdf - 第33页

INFINITY EX TRANS PORTATION MAJOR RELO CATION Chapter Issue 3 J an 04 Technical Reference Manual 31.33 with the end stop pin. 7. Fit the k eyboard to the k eyboard tray , ensure the keyboard is secured to the tray with t…

INFINITY

TRANSPORTATION

MAJOR RELOCATION

31.32 Technical Reference Manual Chapter Issue 3 Jan 04

fits through the washer locating hole, (figure below refers).

3. Locate the MMI arm onto the pivot post of the machine MMI arm support

bracket. Ensure the MMI arm locates onto the bracket dowel correctly so

that arm travel is restricted to an approximate 90

arc of movement.

4. Fit the smaller friction washer, large stainless steel spacer, M12 plain washer

and M12 nyloc nut to the mounting bracket pivot post, (graphic below

refers). Tighten the nut until the MMI arm offers resistance when moved.

5. Slide the machine right hand corner access panel over the MMI arm.

6. Fit the MMI assembly, tube and keyboard tray to the MMI tube and secure

Friction Washer

Locating Dowel

MMI Mounting Pivot Post

Friction Washer

Spacer

INFINITY

TRANSPORTATION

MAJOR RELOCATION

Chapter Issue 3 Jan 04 Technical Reference Manual 31.33

with the end stop pin.

7. Fit the keyboard to the keyboard tray, ensure the keyboard is secured to the

tray with the velcro hook and eye strips.

8. Utilizing the slot in the cable conduit, feed the following cables through the

conduit:

• Monitor Power Supply

• SVGA Cable (M16PL02)

• Touchscreen Cable (M16PL01)

• Keyboard Cable

9. Carefully feed the two button control cable from the rear of the MMI tube

through the cable conduit.

10.Utilizing the three pipe clamps, clip the cable conduit to the rear of the MMI

tube.

11.Connect the cables to the following connections on the rear of the monitor:

• Monitor Power Cable - Power DC-IN

• SVGA Cable - Display Input

End Stop Pin

INFINITY

TRANSPORTATION

MAJOR RELOCATION

31.34 Technical Reference Manual Chapter Issue 3 Jan 04

• Touchscreen Cable - Touch RS-232

12.Gain access to bracket (Pt No 156875) located on the right hand side of the

lower frame.

13.Connect the cables from the MMI to the following connectors fitted to the

bracket:

• Two Button Control (14PL08) - 14SK08

• SVGA Cable (14SK04) - 14PL04

• Touchscreen (14SK02) - 14PL02

• Keyboard Mouse (14PL06) - SK06

• Keyboard (14PL05) - 14SK05 (if Product Barcode Reader not fitted)

NOTE

For machines with the product barcode use the extension cable Pt No 0-

604027-01 to convert the scanner DIN plug to a mini-DIN socket and

connect to 14PL05 from the keyboard. Connect the scanner mini-DIN plug

to 14SK05 to the machine PC.

14.Lay the MMI cables in a neat order and cable tie in position, leaving enough

slack for the MMI to rotate freely.

15.Connect the System button loom to connector 8PL114. Refit the E Stop

connector to the E Stop and ESD cable to the capacitor fixing point.

16.Refit the right hand corner access panel to the machine and fasten using the

three quick release fasteners.

17.Fit the MMI arm earth cable to the machine upper frame earth point.

Fitting of Auxiliary

Conveyors (HTC

Option)

To fit the left hand auxiliary conveyor, carry out the following procedure:

1. Remove the left hand machine side covers.