instruction-manual-product-monitoring-data-acquisition-monitouch-V9-hardware-en.pdf - 第115页
4-14 5. Installing the Battery 7. T urn power ON to the V9 series unit and chec k that the message “Batter y changeover required” is cleared from the lower right of the screen in Local mo de. 8. If a “*.RAM” backup file …
5. Installing the Battery 4-13
4
Installation
V907xiW, V9060iTD
1. Turn OFF power to the V9 series unit.
2. Slide the battery holder cover in the direction of the arrow to remove it. The battery set in the
socket is visible.
3. Disconnect the battery connector, and pull the battery toward the left to remove it from the socket.
4. Insert the new battery into the socket with the side with the red wire facing down. Make sure that
the battery is held in place by the retainers.
5. Attach the battery connector and close the battery holder cover.
6. Write a date five years from the present date for battery replacement on the new caution sticker
and attach the sticker to an open area on the V9 series unit.
* Do not attach the sticker on air holes of the V9 series unit or optional units.
DANGER
Electrical shock hazard!
Turn OFF power to the V9 series unit before performing steps 2 through 6 below.
Rear view
Example: V907xiW
Red wire
Retainer
Retainer
4-14 5. Installing the Battery
7. Turn power ON to the V9 series unit and check that the message “Battery changeover required” is
cleared from the lower right of the screen in Local mode.
8. If a “*.RAM” backup file was saved, transfer it back to the V9 series unit.
Notes on the Battery: EU Directive 2006/66/EC
According to the EU directive 2006/66/EC effective in EU countries, well as the package box of the V9
series and the packaging of the replacement battery have the marking shown below:
CAUTION
The marking shown above is effective only in EU countries.
The details on the marking are designated in Article 20 “Information for end-users”
and ANNEX II in EU directive 2006/66/EC.
The marking indicates that the battery should be disposed of separately from
general household waste.
If element symbols are indicated below the marking, it means that the battery
contains the specified heavy metal at a concentration exceeding the control value.
The concentration control values are given below.
Hg: mercury (0.0005 %), Cd: cadmium (0.002 %), Pb: lead (0.004 %)
The EU has determined the separating program for used batteries.
Dispose of used batteries properly at your local waste-disposal/recycling center.
