00198711-01_UM_X-Serie-S_EN.pdf - 第209页
Instruction manual SIPLACE X-Seri es S 4 Setting up and commissioning From software version 713.0 Edition 11/2019 4.3 Setting up the placement machine 209 4 Fig. 4.3 - 4 Placement machine feet (example of SIPLACE X2 S / …
4 Setting up and commissioning Instruction manual SIPLACE X-Series S
4.3 Setting up the placement machine From software version 713.0 Edition 11/2019
208
4
With the fork-lift, raise the placement machine approximately 35 cm. This prevents the risk of
any injuries to your feet if the machine feet are unintentionally lowered.
The placement machine stands on 6 feet.
– 4 outer machine feet (item 1 in fig. 4.3 - 4
, page 209 )
– Outer machine feet for the PCB conveyor heights 900,930 and 950 mm, length
439 mm, Item no. 03000890-02 (item 1 in fig. 4.3 - 3
).
– 2 middle machine feet (item 2 in fig. 4.3 - 4
, page 209) with 2 spacers (item 3 and item 4 in
fig. 4.3 - 4
, page 209) for height adjustment, where necessary.
4
Fig. 4.3 - 3 Outer machine feet - two versions (dimensions in millimeters)
WARNING
Risk of damage due to one-sided loading!
One-sided loading of the machine feet e.g. from tilting the placement machine, can lead
to deformation of the machine feet fixtures.
Make sure that the forks are evenly loaded when you lift the placement machine.
Use a firm support layer between the forks and the placement machine.
Enlist the help of a second person to watch while you lift the placement machine and
make sure that the placement machine does not tip over to one side.
Instruction manual SIPLACE X-Series S 4 Setting up and commissioning
From software version 713.0 Edition 11/2019 4.3 Setting up the placement machine
209
4
Fig. 4.3 - 4 Placement machine feet (example of SIPLACE X2 S / X3 S / X4 S shown)
4
(1) Outer machine foot, 4 x, 2 versions (see fig. 4.3 - 3, page 208 )
(2) Middle machine foot, 2 x
(3) Spacer on the side of the power supply unit
(2)
(2)
(1)
(1)
(1)
(1)
(3)
4 Setting up and commissioning Instruction manual SIPLACE X-Series S
4.3 Setting up the placement machine From software version 713.0 Edition 11/2019
210
4.3.6.1 Presetting the height of the middle machine feet
The middle machine feet are preset first of all. The spacer must be screwed to the correct position
on the underside of the placement machine: this will vary according to the height of the placement
machine.
Setting a board conveyor height of 900 mm 4
You do need a spacer for a board conveyor height of 900 mm.
Make sure that the 90 mm side of the spacer is vertically aligned and the hole for the middle
machine foot indicates downwards.
4
4
4
4
4
4
4
4
4
4
4
4
Fig. 4.3 - 5 Aligning the spacer for a conveyor height of 900 mm
4
(1) Spacer height of 90 mm
(2) Middle machine foot
(3) Lock nut M24
(4) Hexagon socket head screw M12x80, 4x