00198711-01_UM_X-Serie-S_EN.pdf - 第281页
Instruction manual SIPLACE X-Series S 5 Tasks at the placement machine From software version 713.0 Edition 11/2019 5.14 Docking the component trolley in or out 281 5 Fig. 5.14 - 1 Safety instructions for docking the comp…
5 Tasks at the placement machine Instruction manual SIPLACE X-Series S
5.14 Docking the component trolley in or out From software version 713.0 Edition 11/2019
280
5.14 Docking the component trolley in or out
5.14.1 Safety instructions for docking component trolleys in and out
Also follow the safety instructions given in section 2.5.10, page 73.
5
In addition, the component trolley can only be docked in if the protective
covers are closed.
There is a button at each location (1,2,3 and 4) for docking and undocking the component trolley.
The safety concept for the component trolley changeover specifies that the operator should push
this button at the relevant placement machine location, to dock or undock the component trolley.
WARNING
DANGER OF CRUSHING!
Risk of crushing when docking and undocking the component trolley.
Always dock/undock the component trolley alone.
When docking and undocking, make sure that there are no body limbs in the travel
area of the component trolley.
Instruction manual SIPLACE X-Series S 5 Tasks at the placement machine
From software version 713.0 Edition 11/2019 5.14 Docking the component trolley in or out
281
5
Fig. 5.14 - 1 Safety instructions for docking the component trolley in or out (example of SIPLACE X2 S / X3 S / X4 S
shown)
In addition, the component trolley can only be docked in if the protective
covers are closed.
(1) Button for docking and undocking the component trolley at location 1
(2) Button for docking and undocking the component trolley at location 2
(T) Direction of PCB transport
5.14.2 Docking out the component trolley
Press the docking/undocking button on the respective placement machine location until the
component trolley is completely undocked.
Swivel the two handles up (item 1 in fig. 5.14 - 2).
(1)
(2)
5 Tasks at the placement machine Instruction manual SIPLACE X-Series S
5.14 Docking the component trolley in or out From software version 713.0 Edition 11/2019
282
5
Fig. 5.14 - 2 Component trolley - swivel handles up to push
With both hands on the handles, pull the component trolley out of the placement machine.
5.14.3 Safety instructions for moving the component trolley
5
Always hold the handles with both hands when you want to move the component trolley.
Remember that a component trolley with the full complement of feeder modules can tip over
sideways or forward on gradients of 20° or more.
Make sure that the surface on which the trolley is moved has a significantly smaller gradient.
Be careful not to collide with obstacles. The trolley could tip forward if it is traveling fast
enough.
WARNING
Avoid accidents!
To prevent accidents, ALWAYS follow the rules listed below when you move the compo-
nent trolley.