00191369-01.pdf - 第330页
7 What schould you do ... User’s Manual S IPLACE HS-50 7.7 Changing the set-up Software Version SR.501.xx Edition 01/99 328 &KDQJLQJWKHVHWXS Before cha nging the set-u p, print out t he instruct ions regar din…
User’s Manual SIPLACE HS-50 7 What schould you do ...
Software Version SR.501.xx Edition 01/99 7.6 Preliminary set-up of the placement station
327
Å Make sure that the spacing in the tape transport of the feeder is correct.
Å Shorten the used tape on the front of the feeder module to a length of 3 cm.
Å Check to see if the dividing plates in the tape container are inserted correctly (see Fig. 7.5 - 2).
Å Check the diameter of the component tape reels and insert a shaft for large reels.
Å Splice short tape ends together.
The personnel maintaining the preliminary set-up area is to have access to the same equipment
as the machine operators. You will find a list of such equipment in section 7.10
.
NOTE
If the equipment is defective, then the machine operator is to inform the personnel in the prelimi-
nary set-up area verbally or in writing.
7 What schould you do ... User’s Manual SIPLACE HS-50
7.7 Changing the set-up Software Version SR.501.xx Edition 01/99
328
&KDQJLQJWKHVHWXS
Before changing the set-up, print out the instructions regarding changing the set-up on the printer
of the line computer as described in chapter 14 of the ’UNIX line computer’ User’s Manual.
:KDW\RXVKRXOGQRWHZKHQFKDQJLQJWKHIHH GHUPRGXOHV
Å Handle the feeder modules carefully when you insert them into or remove them from the com-
ponent table. Do not allow the supporting surfaces of the feeder modules to bang against the
edges of the component table.
Å Vacuum the supporting surfaces of the feeder modules and clean the surface of the component
table when necessary according to the instructions in the maintenance manual.
RISK OF INJURY
Avoid removing components from the magnetic rail of the component table with your fingers
because you may hurt yourself with tiny splinters of metal.
Å Remove loose components with a short-bristled brush.
User’s Manual SIPLACE HS-50 7 What schould you do ...
Software Version SR.501.xx Edition 01/99 7.7 Changing the set-up
329
:KDW\RXVKRXOGQRWHZKHQFKDQJLQJWKHFRPSRQHQWWDEOH
Å Set up the feeder modules in the external set-up area according to the changeover instruc-
tions. Follow the preliminary set-up instructions in section 7.6
.
WARNING
NEVER place your hand in one of the gaps between the component change table and the ma-
chine stand while the machine is running (see Fig. 7.7 - 1, No. 8).
WARNING
The power supply cable for the component table may only be plugged into or unplugged from the
socket on the placement station if the component table is correctly inserted in the set-up area of
the station.
WARNING
It is prohibited to plug the power supply cable for the component table in the socket on the place-
ment station to operate the component table when away from the station via the compressed air
controller.