00191369-01.pdf - 第336页
7 What schould you do ... User’s Manual S IPLACE HS-50 7.8 How to avoid track errors Software Version SR.501.xx E dition 01/99 334 &RPSRQHQWFRRUGLQDWHV\VWHP DQGSLFNXSDQJOH 7 0° 90° 90° SO - I C DI L - I C…
User’s Manual SIPLACE HS-50 7 What schould you do ...
Software Version SR.501.xx Edition 01/99 7.8 How to avoid track errors
333
RQWKHPP6W DSHIHHGHUPRGXOH
Å NEVER open the cover flap without first releasing the tension of the cover foil remover.
Å Set the pick-up position and the spacing of the tape according to the short instructions en-
closed with each tape feeder module.
Å Insert the tape material over the spring into the tape feeder module.
RQWKHWDSHFRQWDLQHU
Å Insert the spacers correctly (see Fig. 7.5 - 2).
Å Use insertable shafts for large tape reels.
7 What schould you do ... User’s Manual SIPLACE HS-50
7.8 How to avoid track errors Software Version SR.501.xx Edition 01/99
334
&RPSRQHQWFRRUGLQDWHV\VWHP DQGSLFNXSDQJOH
7
0°
90°
90°
SO-IC
DIL-IC
0°
SOT 194
90°
90°
SOT 23
Y
X
Vibratory feeder:
Special
C om ponent
Chip
com ponent
with
polarity
0402
2220
C om ponent
ty p e
C oordinate system P osition in the feeder
Pick-up angle
nozzle angle
Tape
Tape
Vibratory feeder:
Tape
Tape
Y
X
Y
X
Holes
Y
X
Y
X
The anode m ust be
aligned w ith the
+ x coordinate
User’s Manual SIPLACE HS-50 7 What schould you do ...
Software Version SR.501.xx Edition 01/99 7.9 What to note when refilling components
335
:KDWWRQRWHZKHQUHILOOLQJFRPSRQ HQWV
The refilling of components with and without a barcode is described in chapter 4, section 4.1.
Å With tape feeder modules, make sure that you always splice on a new tape early enough so
that the feeder modules do not run out of components.
Å However, do not splice the tapes too early because if you wind the tape onto the new reel after
splicing the end of the old tape, the reel with the new tape may be over-filled. The tape could
then slip off the reel and become tangled. Under certain circumstances, this could cause pick-
up errors and prolonged down times.
Å Always insert shafts when using large tape reels and make sure that the dividing plates are
inserted correctly (see Fig. 7.5 - 2
).