00191369-01.pdf - 第337页
User’s Manual SIPLACE HS-50 7 What schould you do ... Software Version SR.501.xx Edition 01/99 7.9 What to not e when refilling components 335 :KDWWRQRWHZ KHQUHILOOLQJFRPSRQ HQW V The refilli ng of comp onents w…
7 What schould you do ... User’s Manual SIPLACE HS-50
7.8 How to avoid track errors Software Version SR.501.xx Edition 01/99
334
&RPSRQHQWFRRUGLQDWHV\VWHP DQGSLFNXSDQJOH
7
0°
90°
90°
SO-IC
DIL-IC
0°
SOT 194
90°
90°
SOT 23
Y
X
Vibratory feeder:
Special
C om ponent
Chip
com ponent
with
polarity
0402
2220
C om ponent
ty p e
C oordinate system P osition in the feeder
Pick-up angle
nozzle angle
Tape
Tape
Vibratory feeder:
Tape
Tape
Y
X
Y
X
Holes
Y
X
Y
X
The anode m ust be
aligned w ith the
+ x coordinate
User’s Manual SIPLACE HS-50 7 What schould you do ...
Software Version SR.501.xx Edition 01/99 7.9 What to note when refilling components
335
:KDWWRQRWHZKHQUHILOOLQJFRPSRQ HQWV
The refilling of components with and without a barcode is described in chapter 4, section 4.1.
Å With tape feeder modules, make sure that you always splice on a new tape early enough so
that the feeder modules do not run out of components.
Å However, do not splice the tapes too early because if you wind the tape onto the new reel after
splicing the end of the old tape, the reel with the new tape may be over-filled. The tape could
then slip off the reel and become tangled. Under certain circumstances, this could cause pick-
up errors and prolonged down times.
Å Always insert shafts when using large tape reels and make sure that the dividing plates are
inserted correctly (see Fig. 7.5 - 2
).
7 What schould you do ... User’s Manual SIPLACE HS-50
7.10 Tools for the operator Software Version SR.501.xx Edition 01/99
336
7RROVIRUWKHRSHUDWRU
All operators are to be equipped with the tools listed in the following. It is recommended to store
the tools in an appropriate container to avoid being injured when removing the tools from the con-
tainer (i.e. by a pair of tweezers).
Every operator of the machine requires:
– SMD tweezers
– A brush with short bristles to clean the component tables
– A set of small regular and Phillips-head screwdrivers
– A tape splicing clamp and splicing materials
– Scissors for splicing tape (do not use multi-purpose scissors or diagonal cutters)
– Erasers or fiberglass pens to remove fiducials
– Indelible pens for marking the tracks
– Cleaning agents (ethyl alcohol, Plexiglass cleaner, cotton wool tips, lint-free cloths, pipe-
cleaners)
– WD40 corrosion protection
– Vacuum cleaner