00198371-01_UM_SWS-EN.pdf - 第35页
User manual SIPLACE Wafer System (SWS) 2 Operational safety Edition 04/2018 2.1 Safety instructions 35 2 Operational safety 2.1 Safety instructions 2.1.1 Conventions for the use of hazard symbols This user manual co ntai…
1 Introduction User manual SIPLACE Wafer System (SWS)
1.5 Important notes on the user manual Edition 04/2018
34
User manual SIPLACE Wafer System (SWS) 2 Operational safety
Edition 04/2018 2.1 Safety instructions
35
2 Operational safety
2.1 Safety instructions
2.1.1 Conventions for the use of hazard symbols
This user manual contains notes that must be observed to guarantee your personal safety and to
avoid damage to equipment. These notes are highlighted by warning triangles and are indicated
as follows according to the level of risk:
2
2
2
2
2
DANGER
Definition
Danger, as used in this user manual, means that death, severe injury or considerable
damage to equipment will occur if the danger instructions are not followed.
WARNING
Definition
Warning, as used in this user manual, means that death, severe injury or considerable
damage to equipment may occur if the warning instructions are not followed.
CAUTION
Definition
Caution, as used in this user manual, means that slight injury or damage to equipment
may occur if the caution instructions are not followed.
PLEASE NOTE
Definition
A note, as used in this user manual, provides information on the product or indicates a
part of the user manual that requires particular attention.
2 Operational safety User manual SIPLACE Wafer System (SWS)
2.1 Safety instructions Edition 04/2018
36
2.1.2 Qualified personnel
Qualified or adequately trained personnel means that these people are familiar with the setting up,
operation and preventive maintenance of the SIPLACE Wafer System and add-on devices and
are suitably qualified, e.g.
– have been trained, instructed or authorized to switch on and off, isolate, earth and identify
electrical circuits and system components in accordance with normal safety standards.
– have been trained or instructed in the upkeep and use of appropriate safety equipment in ac-
cordance with normal safety standards.
– Have received first aid training.
2.1.3 Important notes on operational safety
The following points MUST be observed in order to maintain operational safety:
2.1.3.1 General
The operational safety of the SIPLACE Wafer System can be guaranteed only if the system
is used as prescribed and in accordance with the instructions in the user/preventive mainte-
nance manuals.
Always follow any safety regulations specific to your country.
Make sure that the warning labels are always clearly identifiable and always easily readable.
Replace any damaged warning or notice labels. Replace any labels that are missing.
The machine key for releasing the covers on the SIPLACE Wafer System must be kept in a
safe place where it is only accessible to qualified personnel.
2
If it is necessary to work on the machine and you do not have adequately trained personnel
within your operation, always call in a ASM Assembly Systems GmbH&Co.KG service engi-
neer! ASM Assembly Systems GmbH&Co.KG will not accept liability for any damage or con-
sequential damage that is the result of unauthorized/incorrect work.
If particularly hazardous situations are identified while the SIPLACE Wafer System is in use,
the machine owner must immediately notify the manufacturer in writing so that appropriate
action can be taken to reduce the potential danger.
PLEASE NOTE
Owner's responsibility
The machine owner, and only the machine owner, is responsible for the safekeeping of
the machine key and for ensuring that it is handed over to authorized persons.