00194845-0302_MM_D1_D2_EN.pdf - 第56页
7 4-monthly maintenance jobs SIPLA CE D1 / D2 02/2010 EN E dition 56 7
SIPLACE D1 / D2 7 4-monthly maintenance jobs
02/2010 EN Edition
55
Star brake 7
: Check the star brake for damage and to ensure that it is working correctly.
7
a Wipe the star brake using a dry, lint-free cloth. Make sure that you remove all grease residues.
: Fill each of the three small holes in the star brake with ISOFLEX TOPAS NCA 52.
s Remove excess grease with a lint-free cloth.
7
: Apply a thin film of grease to the surface of the star brake.
7
Vacuum distributor seat 7
d Clean the vacuum distributor seat with a cottonwool bud moistened with ethyl alcohol.
7
Be careful not to push dirt into the vacuum openings with the cottonwool bud. 7
7
7
7
7
7
7
7
7
7
7
7 4-monthly maintenance jobs SIPLACE D1 / D2
02/2010 EN Edition
56
7
SIPLACE D1 / D2 7 4-monthly maintenance jobs
02/2010 EN Edition
57
Valve adjustment drives 7
a Clean the valve adjustment drives and the gap between the disk and the motor bracket with a
dry lint-free cloth.
s Clean the ball bearing with a dry lint-free cloth.
: Check that the ball bearing is working correctly.
: Remove any visible dirt.
7
Turning station 7
d Wipe the black O-ring of the turning station with a lint-free cloth moistened with ethyl alcohol.
: Check the O-ring for damage. Replace, if required.
: Check the toothed belt for damage. Replace, if required.
7
The turning station can be cleaned while still installed using a cottonwool bud moistened with ethyl
alcohol. 7
7
f Press the friction wheel of the turning station against the spring.
f Clean the stop surfaces using a cottonwool bud moistened with ethyl alcohol.
7
Assembly 7
: Insert the two O-rings into the back part of head.
: Carefully insert the vacuum distributor into its seat.
7
The O-rings must not sit on the vacuum distributor as this could damage them. 7
7
7
: Turn the placement star by half a star cycle (approx. 15° - 30°), fit the front part of the head and
screw it tight.
: Attach the ribbon cables to the appropriate connectors.
7
: Insert cleaned or new sleeves into the segments.
: Insert cleaned or new valve plungers into the valve casings.