00194845-0302_MM_D1_D2_EN.pdf - 第73页

SIPLA CE D1 / D2 8 Annual maintenance work 02/2010 EN Edition 73 Check th e protectiv e covers 8 a Open the protective covers t o a height of 100 mm ( +/-5mm) meas ured bet ween the mac hine frame an d the edge o f the p…

100%1 / 86
8 Annual maintenance work SIPLACE D1 / D2
02/2010 EN Edition
72
8
SIPLACE D1 / D2 8 Annual maintenance work
02/2010 EN Edition
73
Check the protective covers 8
a Open the protective covers to a height of 100 mm (+/-5mm) measured between the machine
frame and the edge of the protective cover. Replace the damping cylinder if the damping cyl-
inder covers cannot be held open reliably at this height.
s Use a lint-free cloth to remove any excess oil from the gas spring.
8
: Close the protective covers.
8
Clean the protective covers 8
8
The choice of cleaning agent for the protective covers must be made with particular care so as not
to damage the ESD coating on the protective covers. 8
8
: Check the protective covers for dirt.
: Clean them with a dry lint-free cloth if necessary.
If it is very dirty, use a lint-free cloth and a small amount of a neutral or weak alkaline cleaning
agent.
8
This must NOT be 8
– acidic or strong alkaline,
– contain ketones, esters, aromatics, halogenated hydrocarbons, etheric oils or similar.
8
Apply as little pressure as possible when cleaning the protective covers to avoid damaging the
ESD coating. 8
8
: After cleaning, wipe over with fresh water.
8
8
8
8 Annual maintenance work SIPLACE D1 / D2
02/2010 EN Edition
74
8.1 Maintenance of the Pick&Place module (SIPLACE
D1 only)
8