00198377-01_SM_JTF-ML2_en.pdf - 第109页

4 Conveyor Mechanics 4.8 Replacing the Toothed Belt Service Manual SIPLACE JTF-ML2 08/2017 109 ► Remove the two screws ISO 4762 - M 4 x 8- A2-70 [03042551-xx] (1) and the screw ISO 10642 - M3x6-A2-70 [03082814-xx] (2) . …

4 Conveyor Mechanics

4.8 Replacing the Toothed Belt

108 Service Manual SIPLACE JTF-ML2 08/2017

4.8 Replacing the Toothed Belt

Parts, Equipment and Tools

●

Standard tools

●

Toothed belt 10+-0.1 S2M/726 [03130743-xx]

Removal

► Switch off the machine, disconnect it from the power supply and secure it to prevent

unauthorized reactivation. Observe the instructions in section 1.2 "Preparatory Work..." [}11].

► Remove the conveyor (See 2.1.1 "Removing Conveyor from Machine" [}17]).

► Remove the four screws DIN EN ISO 7380-M3 x

5-A2-70 [03045193-xx] (1).

► Remove the Conveyor motor cover [03145679-

xx] (2).

NOTICE

Same part numbers

Mark the cables before removing them. Both cables have the same part number.

► Remove the two cables (1) from the BLDC motor

BGA22x22 w/ gearbox/encoder [03128938-xx].

4 Conveyor Mechanics

4.8 Replacing the Toothed Belt

Service Manual SIPLACE JTF-ML2 08/2017 109

► Remove the two screws ISO 4762 - M 4 x 8-

A2-70 [03042551-xx] (1) and the screw ISO

10642 - M3x6-A2-70 [03082814-xx] (2).

► Remove the Left rail cpl.[ 03146884-xx] (1).

Left rail cpl.[ 03146884-xx]

► Loosen socket head shoulder screw M4x5x16

[03145465-xx] (1) to right to loosen the tension

on the Toothed belt 10+-0.1 S2M/726 [03130743-

xx] (2).

► Remove the Toothed belt 10+-0.1 S2M/726

[03130743-xx] (2).

4 Conveyor Mechanics

4.8 Replacing the Toothed Belt

110 Service Manual SIPLACE JTF-ML2 08/2017

Installation

► Follow the removal instructions in reverse order for installation. Also observe the following in-

structions:

► After you put back the Toothed belt 10+-0.1

S2M/726 [03130743-xx], move and fasten the

Roller f. adjust [03129009-xx] with the loosen

socket head shoulder screw M4x5x16

[03145465-xx] (1) again to heighten the tension

on the belt.

► Test the belt tension (1) with a belt tension meas-

uring device.(2).

► Repeat the process until the belt tension is at 70

+/-5 Hz.