iTAC Advance Issue 2, Mar 2018.pdf - 第16页

16 Issue 2 , Mar 18 For DEK machine is only important the paste, click on paste and check whether field setup is set to traceability. Note: Field Setup activ ates or deactivates monitoring of material setup. That means i…

Issue 2, Mar 18

Note: The site/station parameters above should be checked if some of the features will not

work correctly.

NOTES:

BOM Module - Bill of Material

Bill of Material module is used for creating & editing of BOMs.

❑ Go to BOM

To load the BOMs click on any field and type ("*"), then click on Load BOM button, all BOMs should

be displayed.

To Display what contains the BOM right click, selection window will be displayed, then select Display

BOM.

Issue 2, Mar 18

For DEK machine is only important the paste, click on paste and check whether field setup is set to

traceability.

Note: Field Setup activates or deactivates monitoring of material setup. That means if Setup is

set to none material is not checked. Setup field should be always set to traceability.

Note: iTAC is using the older terminology for naming of layer:

1. Component side (usually Top side)

2. Solder side (usually Bottom side)

3. Position independent

Issue 2, Mar 18

Objective HO 4: Create new version of BOM.

BOM editing – new version release

❑ Right click then select edit BOM.

❑ The BOM can be edited by right click, in selection windows can be selected insert/remove

component, edit process data, etc.

❑ Once required changes are done click on close in toolbar.

❑ Then will be prompted whether release BOM for editing by other users or not.