CP-7[732-742]-series Mechanical Reference(2.9E).pdf - 第111页
2.15 Lubricating the Rear Cover Arrow marks in the illustration indicate lubrication points. Note: The above drawing represents the CP-732E. Please conduct lubrication for the CP-742ME and CP-742E in the same fashion. C7…
2.14 Lubricating the Nozzle Changer
Arrow marks in the illustration indicate lubrication points.
C7SM3024b
14 ST
(45)
(49)
(48)
(45)
(46)
(47)
(49)
(49)
Lightly remove the applied
grease, leaving behind a
thin film
Note: Apply AFC grease to the outside surface of the
thrust bearing and rotate it to work the grease
into the bearing.
Disassembly is not required.
AFC grease
AFC grease
Monthly
Monthly
Daphne Exponex No. 2
T013a
Lubrication points
Schedule
Types of lubricant
45
46
Spline shaft
Beveled gear
Every 3 months
Monthly
Monthly
Daphne Exponex No. 2
Daphne Exponex No. 2
47
48
49
Moveable sections on the lever
Clutch engagement surface
Thrust bearing
Part 3 Chapter 2 Lubrication
Edition 2.9 3-2-19 CP-7 series Mechanical Reference
2.15 Lubricating the Rear Cover
Arrow marks in the illustration indicate lubrication points.
Note: The above drawing represents the CP-732E. Please conduct lubrication for the CP-742ME
and CP-742E in the same fashion.
C7SM3029a
(50)
(50)
(50)
(50)
(50)
(50)
(50)
(50)
Daphne Exponex No. 2 Every 3 months
T016Ea
Lubrication points
Schedule
Types of lubricant
50
Slide rail
Part 3 Chapter 2 Lubrication
Edition 2.9 3-2-20 CP-7 series Mechanical Reference
2.16 Lubricating the Index Unit
Point
The lubricant for the index unit in the cam box is contained within the oil cooler on the
left side of the box. Replace the oil in the oil cooler once every three years or after 12,000
hours of operation.
Procedure
The oil in the oil cooler can be drained at three locations. Refer to the diagram below for
guidelines on how much oil should be removed from each drain plug.
Prepare in advance a bucket for collecting the old oil, a plastic sheet with which to cover
the machine, and some corrugated cardboard.
C7SM3102
Oil cooler drain plug
(approx. 2,000 ~ 3,000 cc)
Oil inlet
(51)
Nozzle index drain plug
(approx. 1,000 cc)
Theta (θ) index drain plug
(approx. 1,000 cc)
SHC 630
Every 3 years or
12,000 hours
Oil cooler
T014c
Lubrication points
Schedule
Types of lubricant
51
Part 3 Chapter 2 Lubrication
Edition 2.9 3-2-21 CP-7 series Mechanical Reference