CP-7[732-742]-series Mechanical Reference(2.9E).pdf - 第64页

Notes: Part 2 Chapter 1 Changing the Conveyor Width Edition 2.6 2-1-2 CP-7 series Mechanical Reference

1. Changing the Conveyor Width

Point

Conveyor width adjustments must be performed jointly at the in-conveyor, XY-table,

and out-conveyor. The conveyors should be adjusted to a width which permits smooth

panel clamping and conveyance through the machine.

Procedure

CAUTION

Before performing conveyor width adjustment, check the

back-up pin positions on the XY-table, verifying that there

will be no interference between the back-up pins and the

adjustable rail.

1. Execute the necessary commands to link the XY-table to the in and out-conveyors.

At the touch panel’s main screen, select the following commands: [Conveyor] -

[Conveyor Width] - [Change Width], then press the START button.

2. Turn the handle on the out-conveyor to adjust the conveyor width until the panel

can be conveyed smoothly. First increase the conveyor width then reduce it to

between 0.5~1.0 mm wider than the panel width.

3. Lower the XY-table.

4. Run a test panel through the machine, verifying that it is conveyed smoothly and

that panel clamping is correctly performed.

W+(0.5~1.0)

(mm)

C7SM2001a

Panel

C7SM2007

Handle

Part 2 Chapter 1 Changing the Conveyor Width

Edition 2.6 2-1-1 CP-7 series Mechanical Reference

Notes:

Part 2 Chapter 1 Changing the Conveyor Width

Edition 2.6 2-1-2 CP-7 series Mechanical Reference

2. Changing the Panel Back-up Pin Positions

Point

The positions and quantity of back-up pins or rubber blocks which are required depends

on the panel shape and size, with consideration given to pre-mounted parts on the lower

side of the panel.

For panels where upward warping is a problem, back-up pins with vacuum pads should

be used to keep the panel flat.

Procedure

1. Execute the necessary commands to move the XY-table to the loading position.

2. Raise the XY-table.

3. Press the EMERGENCY STOP button.

WARNING

Turn the main power off before performing this procedure.

4. Change the positions of the back-up pins or rubber blocks as required.

Loosen the pin mounting bolts and reconfigure the pins as necessary.

C7SM2004a

Back-up pin

C7SM2002a

Vacuum pad

Back-up pin Rubber block

Part 2 Chapter 2 Changing the Panel Back-up Pin Positions

Edition 2.0 2-2-1 CP-7 series Mechanical Reference