CP-7[732-742]-series Mechanical Reference(2.9E).pdf - 第168页

1.6.1 Feeder Check Sensor Position Adjustment 1. Press the EMERGENCY STOP button to turn off the 200V power, leaving only the 100V power on. W ARNING Always be sure to cut off the 200V power before carrying out any work.…

1.6 Feeder Height Error Detection (Station 1)

Point

To detect the positions of the feeders, two sets of sensors are used at each of the retract

areas. A further pair of sensors are also used at the pickup position, bringing the total

number to five.

A dedicated jig is used to position these sensors. The sensitivity of the sensors must also

be adjusted.

Note: The above figure represents device table one, but the same arrangement can also be found

on device table two.

The jig used to adjust the sensor positions is shown below.

Positioning jig body

(ADCPJ8020)

Block

(DCPJ0040)

Block

(DCPJ0050) < For CP-732E/CP-742ME >

Block

(DCPJ0060)

Block

(DCPJ0070)

Block

(DGPJ5070) < For CP-742E >

C7SM4049b

Feeder check sensor

(D1 retract area upper direction check)

Feeder check sensor

(D1 retract area lower direction check)

Feeder check sensor

(Pickup area upper direction check)

C7SM4022a

Part 4 Chapter 1 Station Adjustments

Edition 2.4 4-1-17 CP-7 series Mechanical Reference

1.6.1 Feeder Check Sensor Position Adjustment

1. Press the EMERGENCY STOP button to turn off the 200V power, leaving only the

100V power on.

WARNING

Always be sure to cut off the 200V power before carrying

out any work.

2. Set the positioning jig body on a feeder pallet.

3. Use the inching keys to position the feeder pallet and bring the positioning jig

body within the vicinity of the sensor in question.

4. Attach a block appropriate for each sensor within the jig and then adjust the

sensor position.

Pick-up Area

Block

(DCPJ0040)

Sensor bracket

C7SM4050a

Part 4 Chapter 1 Station Adjustments

Edition 2.4 4-1-18 CP-7 series Mechanical Reference

D1, D2 Retract Area (Upper direction check)

Inner sensor

Outer sensor

<CP-732E, CP-742ME>

<CP-742E>

C7SM4057a

Sensor bracket

Block (DGPJ5070)

Block (DCPJ0050)

C7SM4051a

Sensor bracket

Block

(DCPJ0040)

Sensor bracket

C7SM4050a

Part 4 Chapter 1 Station Adjustments

Edition 2.4 4-1-19 CP-7 series Mechanical Reference