CP-7[732-742]-series Mechanical Reference(2.9E).pdf - 第67页

3. Setting the Feeders Point Feeders must be set on the pallets in the correct manner in order for the nozzles to pick up parts. Refer to the CP Feeders Mechanical Reference (MEC-CPFDR-x.xE) for details. Procedure W ARNI…

Snap the blocks into suitable lengths and use double-faced tape to stick them to

the panel lifter’s back-up plate.

C7SM2003a

Rubber block

Part 2 Chapter 2 Changing the Panel Back-up Pin Positions

Edition 2.0 2-2-2 CP-7 series Mechanical Reference

3. Setting the Feeders

Point

Feeders must be set on the pallets in the correct manner in order for the nozzles to pick

up parts. Refer to the CP Feeders Mechanical Reference (MEC-CPFDR-x.xE) for details.

Procedure

WARNING

Turn the main power off before performing this procedure.

1. Verify that the tape guide is not deformed.

2. Place the various part tapes in their dedicated feeders. If a part tape is placed in

the wrong feeder, the tape guide may not close properly.

3. Insert the catch on the base of the feeder into the channel beneath the guide. Push

the feeder forwards and then press the back of the feeder down to clamp it firmly

in position.

Clamper

Guide channel

Feeder

C7SM2009

C7SM2005a

Correct Incorrect

Part 2 Chapter 3 Setting the Feeders

Edition 2.4 2-3-1 CP-7 series Mechanical Reference

13 and 15 inch parts reels should be positioned using the three rubber stoppers.

When setting, ensure that the feeder base and reel itself are positioned in the same

slot. Correct parts supply will not be possible if feeders are incorrectly set as

shown in the figure below.

4. When setting a feeder on a pallet, be sure that there is no foreign matter (waste

tape, etc) between the feeder and the pallet. Remove any foreign matter which has

adhered to the pallet grooves or to the bottom of the feeder.

Waste tape

Pallet

Feeder

C7SM2006

Reel holder

Rubber brace Rubber brace

Rubber brace

View of pallet from above

C7SM2010

Part 2 Chapter 3 Setting the Feeders

Edition 2.4 2-3-2 CP-7 series Mechanical Reference