CP-7[732-742]-series Mechanical Reference(2.9E).pdf - 第90页

1.14 Replacing the Nozzle Filter (Every 3 Months) Point The filter inside the shaft becomes soiled during the course of machine operation, and should be replaced approximately every 3 months. If errors occur frequently f…

1.13 Cleaning the Carrier Rodless Cylinder

(Monthly)

Point

There is a tendency for scattered parts and fine fibers etc. to adhere to the slide surface of

the rodless cylinder used to drive the carrier. As a result, it is necessary to perform

periodic cleaning.

Procedure

WARNING

Be sure to turn the main power off before performing this

procedure.

1. Lightly wipe the slide surface of the rodless cylinder using a fine cloth.

Furthermore, ensure to remove any dirt etc. that has accumulated between the

ends of the slider surface and the absorber holder.

2. Apply some grease to a fine cloth and wipe along the slider surface.

Note: Ensure to use Daphne Eponex No. 2 by Idemitsu.

Carrier cylinder

Absorber holder

Slider

Slide surface

Absorber holder

Part 3 Chapter 1 Cleaning

Edition 2.9 3-1-14 CP-7 series Mechanical Reference

1.14 Replacing the Nozzle Filter (Every 3 Months)

Point

The filter inside the shaft becomes soiled during the course of machine operation, and

should be replaced approximately every 3 months. If errors occur frequently for a

specific nozzle, it is probable that the flow of air is being impeded by a dirty filter.

Procedure

WARNING

Be sure to turn the main power off before performing this

procedure.

Squeeze in the levers shown in the figure below, and carefully extract the filter.

Caution:

1. Do not apply excess force to the nozzle shaft.

2. Ensure that the filter is returned to the nozzle with the levers at the bottom.

2. Remove the pin from the filter Assy, and replace both the filter and the pin.

C7SM3111

Filter

C7SM3008

Filter Assy

Part 3 Chapter 1 Cleaning

Edition 2.9 3-1-15 CP-7 series Mechanical Reference

Cleaning Checklist

T015

CheckScheduleCleaning points

1.1

Weekly

1.2

Monthly

1.3

Every 8 Hours

1.4

Every 8 Hours

1.5

Every 8 Hours

1.6

Every 3 Months

1.7

Weekly

1.8

Weekly

1.9

Weekly

1.10

Monthly

1.11

Weekly

1.12

Monthly

1.13

1.14

Monthly

Cleaning the Nozzle Interior

Cleaning the Fluorescent Nozzle Stickers

Emptying the Waste Tape Box

Cleaning the Waste Tape Duct

Emptying the Reject Parts Box

Replacing the Nozzle Filter

Ceaning the Camera Glass

Cleaning the Filter Regulator

Cleaning the Machine Interior

Cleaning the Tapered Clutch on the Nozzle Indexing Shaft

Cleaning the Part Height Check Sensor Lens

Cleaning the Air Filter

Cleaning the Oil Cooler Air Filter

Cleaning the Carrier Rodless Cylinder

Part 3 Chapter 1 Cleaning

Edition 2.9 3-1-16 CP-7 series Mechanical Reference