CP-7[732-742]-series Mechanical Reference(2.9E).pdf - 第152页

1.1.1 Rod Adjustment 1. Set the positioning jig (ADCPJ8020) in the D1 position. 2. Press [Position] - (Position) [D1-axis] - enter [1] - [OK] and the START button to move the positioning jig to station 1. 3. Press the EM…

1. Station Adjustments

1.1 Tape Feed Lever (Station 1)

Point

The pitch lever is the mechanism that advances the parts tape.

The vertical movement of this lever moves the part to the pick-up position.

Two sensors are located in order to check if the tape feed lever reaches the advance limit

and retract limit.

C7SM4002a

Advance sensor

Retract sensor

Tape feed lever (on feeder)

Feeder

Tape feed lever (on machine)

Part 4 Chapter 1 Station Adjustments

Edition 2.4 4-1-1 CP-7 series Mechanical Reference

1.1.1 Rod Adjustment

1. Set the positioning jig (ADCPJ8020) in the D1 position.

2. Press [Position] - (Position) [D1-axis] - enter [1] - [OK] and the START button to

move the positioning jig to station 1.

3. Press the EMERGENCY STOP button to take the 200V down to 100V.

WARNING

• Always be sure to cut off the 200V power before carrying

out any work.

• Exercise extreme caution when working on the machine if

the cam is not at its origin (0 deg.). Recoil of the cam

axis can endanger the operator.

4. Use the cam handle to rotate the cam to 0°.

5. Switch the I/O (TAPE FEED SOL ON) setting ON.

6. Adjust the rod so that there is 0.5 mm clearance between the top of the positioning

jig and the roller.

Adjustment rod

Roller

C73M4001b

0.5 mm

Positioning jig

(ADCPJ8020)

Positioning jig (ADCPJ8020)

Part 4 Chapter 1 Station Adjustments

Edition 2.4 4-1-2 CP-7 series Mechanical Reference

1.1.2 Advance Sensor Position Adjustment

1. When the dog is at the lower limit at cam angle 200°, ensure that the sensor is ON.

2. Set a dial gauge to the roller and adjust the sensor to go off 0.5 mm above the

lower limit.

1.1.3 Retract Sensor Position Adjustment

1. When the dog is at the upper limit at cam angle 0°, ensure that the sensor is ON.

2. Set a dial gauge to the roller and adjust the sensor to go off 0.5 mm below the

upper limit.

Retract sensor

Dog Lower Limit

0.5 mm

Dog Upper Limit

Dog

C7SM4004a

Advance sensor

Dog Lower Limit

Dog Upper Limit

Dog

C7SM4003a

0.5 mm

Part 4 Chapter 1 Station Adjustments

Edition 2.4 4-1-3 CP-7 series Mechanical Reference