CP-7[732-742]-series Mechanical Reference(2.9E).pdf - 第116页

12. Slowly pour the new lubricating oil into the inlet on the top of the oil cooler. 13. Ensure that the surface of the oil is in the range specified by the level indicator. Note: Whether the machine is at rest or during…

9. Open the front doors.

10. Remove the oil from the theta (θ) index unit drain plug.

Use a plastic sheet as shown in the diagram below, remove the drain plug and

drain the old oil into the collecting bucket.

Note: 1. Carefully arrange the plastic sheet to prevent oil spilling on the machine when

draining the oil cooler.

2. The oil removed from the machine should be discarded in accordance with local

ordinances from handling waste matter.

11. Replace and properly tighten the drain plug once the oil has been fully removed.

C7SM3106

Plastic sheet

Drain plug

Part 3 Chapter 2 Lubrication

Edition 2.9 3-2-24 CP-7 series Mechanical Reference

12. Slowly pour the new lubricating oil into the inlet on the top of the oil cooler.

13. Ensure that the surface of the oil is in the range specified by the level indicator.

Note: Whether the machine is at rest or during operation, the oil level does not normally

change. Immediately after replacing the oil after 3 years or 12,000 hours of

operation, the oil level will drop when operating the machine. Following operation,

add more oil until the level falls within the recommended range.

<CP-732E> <CP-742E><CP-742ME>

C7SM3101

Oil range

Oil cooler

Gauge glass

Level indicator

Cap

Oil inlet

(50)

Part 3 Chapter 2 Lubrication

Edition 2.9 3-2-25 CP-7 series Mechanical Reference

2.17 Lubricating the Cam Lever Air Cylinder

Procedure

1. Open the lid of the lubricator with a Phillips driver.

2. Lower the lubricator cover.

3. Visually check the oil level of the oil tank and slowly pour in the oil to the

lubricator. Be sure not to exceed the upper limit while pouring in the oil.

Note The maximum amount of oil that can be supplied to the lubricator is 75 cc. If the oil

level does not reach the tip of the pipe inside the case, there will be insufficient oil to

lubricate the cylinder.

4. Replace the lubricator cover and attach the oil inlet cap.

5. Check and discard of any accumulated waste oil in the collection bottle.

Cam lever air cylinder

(52)

Upper limit

Case

Pipe

Cover

Bottle

Lubricator

Lid

Lower limit

C7SM3084a

Turbine oil + NASKALUBE (*) Every 6 months

T017Eb

Lubrication points

Schedule

Types of lubricant

Air cylinder

(*) The lubrication used is a Fuji special blend (Turbine oil + NASKALUBE).

Contact Fuji when placing an order.

Part 3 Chapter 2 Lubrication

Edition 2.9 3-2-26 CP-7 series Mechanical Reference