CP-7[732-742]-series Mechanical Reference(2.9E).pdf - 第65页

2. Changing the Panel Back-up Pin Positions Point The positions and quantity of back-up pins or rubber blocks which are required depends on the panel shape and size, with consideration given to pre-mounted parts on the l…

Notes:

Part 2 Chapter 1 Changing the Conveyor Width

Edition 2.6 2-1-2 CP-7 series Mechanical Reference

2. Changing the Panel Back-up Pin Positions

Point

The positions and quantity of back-up pins or rubber blocks which are required depends

on the panel shape and size, with consideration given to pre-mounted parts on the lower

side of the panel.

For panels where upward warping is a problem, back-up pins with vacuum pads should

be used to keep the panel flat.

Procedure

1. Execute the necessary commands to move the XY-table to the loading position.

2. Raise the XY-table.

3. Press the EMERGENCY STOP button.

WARNING

Turn the main power off before performing this procedure.

4. Change the positions of the back-up pins or rubber blocks as required.

Loosen the pin mounting bolts and reconfigure the pins as necessary.

C7SM2004a

Back-up pin

C7SM2002a

Vacuum pad

Back-up pin Rubber block

Part 2 Chapter 2 Changing the Panel Back-up Pin Positions

Edition 2.0 2-2-1 CP-7 series Mechanical Reference

Snap the blocks into suitable lengths and use double-faced tape to stick them to

the panel lifter’s back-up plate.

C7SM2003a

Rubber block

Part 2 Chapter 2 Changing the Panel Back-up Pin Positions

Edition 2.0 2-2-2 CP-7 series Mechanical Reference