00198150-02_SM_TX_en.pdf - 第144页
7 Conveyor 7.2 Lifting Table 144 Service Manual SIPLACE TX Series 06/2017 7.2.5 Checking Free Movement of Lifting Table After all work on the lifting table mechanics check the free movement of the lifting table. Fig.191…
7 Conveyor
7.2 Lifting Table
Service Manual SIPLACE TX Series 06/2017 143
7.2.4 Setting the Parallelism and Height of the Lifting Table Plate
DANGER
Press the EMERGENCY STOP!
Before performing adjustment work you must ensure that the lifting table has been secured
against movement!
Overview
Fig.190: Lifting table plate
1. Lifting table plate
2. Fastening screws for lifting table plate
Setting
► Use the software to move the conveyor rails to maximum width.
► Remove the screws fastening the lifting table plate (countersunk screws) but do not remove
the lifting table plate.
► Use the software to clamp the lifting table (without board).
► Underneath the fastening screws, there are setting screws (socket-head5).
Use these setting screws to set the lifting table plate so that it has no play between it and the
clamping edge.
► Check all four corners of the lifting table for any play.
► Check the setting by clamping a board into place. Check all corners to see whether there is
any play.
► Insert and tighten the four screws fastening the lifting table plate.
► Calibrate the zero position of the lifting table motor.
7 Conveyor
7.2 Lifting Table
144 Service Manual SIPLACE TX Series 06/2017
7.2.5 Checking Free Movement of Lifting Table
After all work on the lifting table mechanics check the free movement of the lifting table.
Fig.191: Select operator level
► Click the
button to enter the Settings
menu.
► Click the
button to open the Check and set
user settings menu.
► Switch to operator level Machine service or bet-
ter.
Fig.192: Maintenance menu
► Click the
button to enter the maintenance
menu.
► Click the
button.
► Click the Conveyor motor verification button.
Fig.193: Verify conveyor motors
► Click the Verify conveyor motors button to run
check.
► Click the Generate report button to view details.
See also
2 Replacing the Lifting Table Plate [03114873-xx] [}136]
7 Conveyor
7.2 Lifting Table
Service Manual SIPLACE TX Series 06/2017 145
7.2.6 Calibrating the Lifting Table Motor
After completing the work on the lifting table, this will need to be calibrated.
Procedure
Fig.194: Select operator level
► Click the
button to enter the Settings
menu.
► Click the
button to open the Check and set
user settings menu.
► Switch to operator level Machine service or bet-
ter.
Fig.195: Service menu
► Click the
button to open the Service menu.
► Select Conveyor configuration.
Fig.196: Conveyor menu
► Click the Initiate conveyor parameters
button.
► Click the
buttons to select the re-
quired conveyor lane.
► Go to the All lifting tables section and select the
Calibrate motor button.
► Check the clamps (distance between clamping
plate and clamping rail) and adjust if necessary
(see 7.2.4 "Setting the Parallelism and Height of
the Lifting Table Plate" [}143]).