00198150-02_SM_TX_en.pdf - 第193页
7 Conveyor 7.10 Teaching the PCB Sensors (SW70x) Service Manual SIPLACE TX Series 06/2017 193 Fig.261: Teaching the sensors ► Click on the button Sensors . Fig.262: Teaching the sensors ► Select Laser light barrier at …
7 Conveyor
7.10 Teaching the PCB Sensors (SW70x)
192 Service Manual SIPLACE TX Series 06/2017
7.10 Teaching the PCB Sensors (SW70x)
Whenever you manually loosen the conveyor sides, you also need to reteach the light barrier
sensors. This is required because the light intensity depends on the conveyor width. Without teach-
ing, the conveyor will show boards which are not present, preventing the conveyor from being ref-
erenced.
Teaching is performed automatically during operation.
Procedure
Fig.259: Select operator level
► Click the
button to enter the Settings
menu.
► Click the
button to open the Check and set
user settings menu.
► Switch to operator level Machine service or bet-
ter.
Fig.260: Checking sensors and functions
► Click the
button.
► Click the
button.
► Click on the Conveyor inputs/outputsbutton.
7 Conveyor
7.10 Teaching the PCB Sensors (SW70x)
Service Manual SIPLACE TX Series 06/2017 193
Fig.261: Teaching the sensors
► Click on the button Sensors.
Fig.262: Teaching the sensors
► Select Laser light barrier at conveyor lane 1,
enable Teach board sensors and press the
Start button on the machine.
Disable this function again afterwards.
► Repeat this step for all lanes.
7 Conveyor
7.11 Replacing the Fiducial Rail
194 Service Manual SIPLACE TX Series 06/2017
7.11 Replacing the Fiducial Rail
Parts, equipment and tools
●
Holder with fiducial rail assembly, location 1, with calibration component pocket
[03151908Sxx]
●
Holder with fiducial rail assembly, location 2 [03147052Sxx]
Overview
Fig.263: Holder with fiducial rail (example of location 1 shown)
1. Holder and fiducial rail
The fiducial rail is fixed to the holder (adhesive) and
may not be separated from it.
Removal
► Use the software or manually move the conveyor rail into a position which allows you best ac-
cess.
– To move the conveyor rail manually, pull the toothed belt of the width adjustment unit.
► Switch off the machine, disconnect it from the power supply and secure it to prevent
unauthorized reactivation. Observe the instructions in section 1.2 "Preparatory Work..." [}15].
1. Two screws fastening the fiducial rail - left side
2. Holder and fiducial rail
3. Left holder for fiducial rail
► Remove the two left screws fastening the fiducial
rail.