00198150-02_SM_TX_en.pdf - 第282页

12 SIPLACE TX-Series Component Trolley 12.4 Replacing the Guide Profile/Entering Guide Feeder 282 Service Manual SIPLACE TX Series 06/2017 12.4 Replacing the Guide Profile/Entering Guide Feeder Parts, equipment and tools…

12 SIPLACE TX-Series Component Trolley

12.3 Replacing the Locking Latch [03069205-xx]

Service Manual SIPLACE TX Series 06/2017 281

Overview

Fig.397: Locking latch on component trolley

1. Tape waste container

2. Operation cover

3. Position of complete feeder locking mechanism

4. Locking latch

5. Tension spring

6. Pressure plate (under cover(2))

Removal / Installation

► Remove the waste tape container (1) and empty it.

► Refit the waste tape container. This makes sure that any parts which fall down are not lost.

NOTICE

Waster tape container

You can use the waste tape container as a surface on which to place small parts e.g. ten-

sion springs, locking latches etc.

► Remove the screws fastening the cover plate locking rail [03077142-xx](2). Use a suitable

Phillips screwdriver to avoid damaging the screws.

Fig.398: Removing locking latch

► Unhook all tension springs (1) from the locking

latches (2).

► Remove the screws (3) fastening the pressure

plates(4).

► Pull out the locking latches with the shaft(5).

► The locking latches can now be pushed off the

shaft.

► Return the locking latches, including the new

one, to the shaft.

► Fit the locking latches and shaft.

► During reassembly, take care to keep the pressure plates in their correct position (4). These

are not symmetrical and will not hold the shaft properly if placed in a certain (incorrect) posi-

tion.

► When tightening the fastening screws (3), make sure that the pressure plates (4) are not at an

incorrect angle and that the locking latches do not jam.

► Hook the tension springs (1) back up.

► Refit the cover.

12 SIPLACE TX-Series Component Trolley

12.4 Replacing the Guide Profile/Entering Guide Feeder

282 Service Manual SIPLACE TX Series 06/2017

12.4 Replacing the Guide Profile/Entering Guide Feeder

Parts, equipment and tools

Select the required spare part:

●

Short guide profile [03002898-xx]

●

Insert feeder [03039368-xx]

Overview

Fig.399: Guide profiles on component trolley

1. Short guide profile

2. Feeder entering guide

The short guide profiles are fixed from above with one

screw each.

The feeder entering guide is fixed from below with four

screws each.

12 SIPLACE TX-Series Component Trolley

12.5 Replacing the Bearing Assembly (Centering Sleeve) [03103947-xx]

Service Manual SIPLACE TX Series 06/2017 283

12.5 Replacing the Bearing Assembly (Centering Sleeve)

[03103947-xx]

Parts, equipment and tools

●

Bearing assembly [03103947-xx]

●

Loctite 243 [00334892‑xx]

NOTICE

Always replace all bearing assemblies

We recommend that you always replace all bearing assemblies belonging to a changeover

table at the same time.

Overview

Fig.400: Bearing assemblies on component trolley

1. Bearing assemblies (fourper table)

Removal

► Remove the screw fastening the bearing assembly and then remove the centering sleeve.

Installation

► Follow the removal instructions in reverse order for installation. Also observe the following in-

structions:

CAUTION

Installation instructions

► Secure the screws with Loctite 243.