4OM-1208-011_w.pdf - 第113页
1-56 AIVEMT -ID 4.5 Cleaning of Linear Measure Sensor Periodically perform cleaning of the linear measure sensor to maintain reliable and stable measurement of component thickness. • Clean the sensor every day . • Change…
1-55
AIVEMT-ID
(9) Put the flat ring replacement jig on the roller on the oscillating side
(outside of the machine).
Push only the flat ring downward by hand and insert it into the groove
of the roller.
Flat Ring
Fig. 4A54
(10) Pay attention to the cutter blade and detach the flat ring replacement
jig.
(11) Attach the tape guide and the transparent cover.
0606-009
4.4 Procedure of Flat Ring Replacement
1-56
AIVEMT-ID
4.5 Cleaning of Linear Measure Sensor
Periodically perform cleaning of the linear measure sensor to maintain
reliable and stable measurement of component thickness.
•
Clean the sensor every day.
•
Change cleaning frequency according to varying frequency of use and
environmental conditions.
Conic Cap
Linear Measure Sensor
(Light Emitter)
Linear Measure Sensor (Light Receiver)
Surface of Conic
Reflector
Horizontal Direction
Linear Measure Sensor (Light Emitter)
Fig. 4A55
•
While you are cleaning the light emitter
, the surface of the conic refl
ector
must be cleaned softly and horizontally
.
Notice
Cleaning it vertically may damage the conic cap.
When the conic cap is damaged, the component recognition might
not be made correctly.
0606-009
4.5 Cleaning of Linear Measure Sensor
1-57
AIVEMT-ID
Preparation for Cleaning
(1) Lens Cleaning Cloth (Accessory)
(2) Cotton Swab
(3) Recommended Absolute Ethanol : C
2
H
2
O 99.5 vo1/%
(High Purity)
Cleaning Procedure
(1) Press the [LINE MEAS] button on the "PERIODIC MAINT" submenu
bar. The "LINEAR MEASURE CLEANING" window appears.
(Operation Sequence: [MAINT] Button on Main Menu Bar
→
[PERIODIC MAINT] Button on Submenu Bar
→
[LINE MEAS]
Button)
Fig. 4A56 "LINEAR MEASURE CLEANING" Window
(
2) Select the head whose linear measure sensor should be cleaned.
(3) Pre
ss the [Nozzle Reset] button to store the vacuum nozzle in the nozzle
stocker (housing).
(4) Press the [READY] switch of the pertinent stage. The LED
extinguishes.
The cover is unlocked.
0606-009
4.5 Cleaning of Linear Measure Sensor