4OM-1208-011_w.pdf - 第83页
1-26 AIVEMT -ID 3.3.5 Feeder Cart Section C A U T I O N While attach ing the handle sli des, be sure to pre vent your fingers from getting jammed. Be sure to firmly hold the handle to bend and extend. Otherwise, the handle…
1-25
AIVEMT-ID
3.3.4 Feeder Base Driving Section
Worm Gears
(2 places)
Every 3 Months Lubrication
(MOLYNOC GREASE AP1)
Required Time: 2 minutes
Apply a small amount of new grease to the
worm gears with a syringe.
Use No. 19 (brown) nozzle.
Note
No. 19 (brown)
Fig. 4A16-1
0606-009
3.3 Inspection, Cleaning, and Lubrication Spots
1-26
AIVEMT-ID
3.3.5 Feeder Cart Section
CAUTION
While attaching the handle slides, be sure to prevent your fingers
from getting jammed.
Be sure to firmly hold the handle to bend and extend.
Otherwise,
the handle will fall, causing an injury
.
Pay special attention to the handle's up/down sliding portion to prevent
fingers from being pinched.
Groove on Feeder Base
Every Week Cleaning
Required Time: 2 minutes
Suck dirt and dust with a vacuum cleaner.
Upper Surface of Feeder Base
Every Day Cleaning
Required Time: 2 minutes
Remove foreign substances and unrequired
components with a vacuum cleaner and
wipe off dirt and dust with a rag.
Fig. 4A17
0611-010
3.3 Inspection, Cleaning, and Lubrication Spots
1-27
AIVEMT-ID
Scrap Box
Every Day Cleaning
Required Time: 1 minute
Draw out the scrap box and remove the
empty tape.
Fig. 4A18
Upper Surface of Suppressor
Every Day Cleaning
Required Time: 2 minutes
Remove dirt and dust with a vacuum
cleaner and wipe the surface clean with a
rag.
Fig. 4A18-1
0606-009
3.3 Inspection, Cleaning, and Lubrication Spots