00900194-01_SM_ASM ProcessLens_Dual-lane_EN.pdf - 第25页
3 Replacing spare parts 3.2 DLP Service Manual ASM ProcessLens Dual-lane 09/2018 25 ► Unscrew and remove the two screws (1) that connect the connector with the DMD module by using an Allen key size 1.5. ► Carefully lift…
3 Replacing spare parts
3.2 DLP
24 Service Manual ASM ProcessLens Dual-lane 09/2018
3.2 DLP
3.2.1 Replacing the DLP left and right controller
Parts
Fig.3: Right DLP module (1)
03139342-xx In-house left DLP module
03139345-xx In-house right DLP module
Equipment and tools
●
Allen key size 1.5
●
Allen key size 2.0
●
Philips screwdriver
Requirements
●
Machine is switched off.
Removal
► Unscrew and remove the three screws(1) using
a Philips screwdriver to remove the cover of the
DLP module (circuit board).
► Unscrew and remove the three screws(2) using
a Philips screwdriver to remove the cover of the
DMD module (connector).
CAUTION!
Small screws
The screws are very small. When the screws fall
into the machine they may damage it.
Make sure the screws don’t fall into the machine.
Make sure no screw is left behind inside the
machine.
.
3 Replacing spare parts
3.2 DLP
Service Manual ASM ProcessLens Dual-lane 09/2018 25
► Unscrew and remove the two screws(1) that
connect the connector with the DMD module by
using an Allen key size 1.5.
► Carefully lift the connector of DMD module.
► Unscrew and remove the three screws(2) of the
DLP module by using an Allen key size 2.0.
► Remove the circuit board and replace it.
► The steps for the left and the right module are
identical.
Installation
Follow the removal instructions in reverse order for installation.
NOTICE
Modules are not interchangeable
Be aware that the two modules are not interchangeable.
3.2.2 Checking the DLP module
Requirements
●
DLP module is dismantled.
Checking the module
► Put the DLP module in its position.
► On the DLP interface board to the DMD(3) make
sure that the connector(2) is in the right position
and does not bend the pin(1). Use an external
light to check that the holes of the connector and
the drilling holes for the screws are in line.
► If the connector and the pin are in line a notice-
able click sound can be heard when the con-
nector is pressed down.
3 Replacing spare parts
3.2 DLP
26 Service Manual ASM ProcessLens Dual-lane 09/2018
3.2.3 Checking the software version of the DLP module
When the DLP module and the DMD module have been changed, a software check for the latest
Version is needed.
Requirements
●
Machine is switched on.
Checking the software version
► Open the DLP controller software on the computer.
► Double click on the application to run the software.
► In the Module ID input field(1) enter the number "00" for the left DLP module or "01" for the
right DLP module to test the left or the right DLP module and click on Connect(2).
► Click on Get Version(3) to check if the software version is running the latest version.
► Go to the ASM internal website to check the software version.