00900194-01_SM_ASM ProcessLens_Dual-lane_EN.pdf - 第61页
4 Replacing spare parts at the conveyor 4.4 Width adjustment Service Manual ASM ProcessLens Dual-lane 09/2018 61 Removal CAUTION Small parts ► Take care not to lose any small parts. ► Take particular care not to let the …
4 Replacing spare parts at the conveyor
4.4 Width adjustment
60 Service Manual ASM ProcessLens Dual-lane 09/2018
4.4.3 Replacing the clamping unit
Parts
Fig.35: Clamping unit
03121328-xx Clamping unit 4 complete M-C
Equipment and tools
02101037‑xx Loctite 241
00353832-xx Allen key set
00376503-xx Torx L-Wrench Set with Spherical head (Torx 30)
Overview
Fig.36: Clamping unit
1. Clamping unit on conveyor rail
2. Clamping unit complete
3. actuator
4 Replacing spare parts at the conveyor
4.4 Width adjustment
Service Manual ASM ProcessLens Dual-lane 09/2018 61
Removal
CAUTION
Small parts
► Take care not to lose any small parts.
► Take particular care not to let the screws fall into the conveyor rail when removing the
screws or clamping plate.
► Use the software or manually move the conveyor rail into a position which allows you best
access.
– To move the conveyor rail manually, pull the toothed belt of the width adjustment unit.
► Switch off the machine, disconnect it from the power supply and secure it to prevent
unauthorized reactivation.
► Remove the lifting table plate to make room for removing the actuator later (see chapter 4.2.1
"Replacing the lifting table plate" [}38]).
Fig.37: Removing clamping plate
► Insert the small pin or Allen key(3) to fix the
actuator.
► Remove the two screws(2) fastening clamping
plate(1).
First loosen one screw slightly, and then loosen
the other screw slightly. After that, remove both
screws completely.
► Remove inserted Allen key and remove the
actuator from bottom side.
► Remove the clamping plate(1) with two fastening
screws carefully.
Installation
► Follow the removal instructions in reverse order for installation. Also observe the following
instructions:
CAUTION
Installation instructions
► Secure the two screws fastening the clamping unit with Loctite 241.
4 Replacing spare parts at the conveyor
4.4 Width adjustment
62 Service Manual ASM ProcessLens Dual-lane 09/2018
4.4.4 Calibrating the Track Zero Point
After completing all work to the width adjustment (adjustment unit, motor or belt of width adjust-
ment), you need to configure the adjustment unit before you configure the conveyor sides.
Procedure
► Click on this icon(1) to enter the settings menu.
► Click on Unit Function(2) to enter the settings user menu.
► Switch to operator level Machine service.
► Click on System Test(3) to enter the calibration menu.
► In the Track Width Calibration area(4) select the right track.
► Click on the Track Zero Point Calibration button(5) to calibrate the track zero point of the
right track.
► Repeat the calibration the same way for the left track.