MAN00000772_SI-G200BB_SVCPDFA.pdf - 第339页

Adjustment HLGB-10415-01 Nozzle Sensor Adjus tment SHEET 7/7 5. Remove the nozzle f or production installed on the turret No. 1. 6. Press the SET button again. The LEDs from NEAR to F AR turn on green. 7. Set the mode se…

100%1 / 712
Adjustment
HLGB-10415-01
Nozzle Sensor Adjustment
SHEET
6/7
4 Select a nozzle sensor coordinate space
and click the XY button for teaching.
XY teaching screen is displayed.
If the Teaching button does not become enabled,
click on the “Nozzle sensor coordinate” column
and then click the Teaching button again.
5 Move the head to the set teaching position.
1. Click the Set the nozzle tip button.
2. Press the [START] button on the
operation panel.
The head moves to the currently set position.
Do not click the Acq. Pos. button.
6 Set a threshold value with the nozzle sensor.
1. Open the sensor cover.
2. Set the mode set switch to TEACH.
3. Check that the NORM/ZONE switch is
set to NORM.
4. Press the SET button.
The LEDs from NEAR to FAR turn on red.
OUT
SET
NORM
TEACH
RUN
ADJ
ZONE
L
D
NEAR
FAR
NORM/ZONE switch
Mode set
switch
SET button
Adjustment
HLGB-10415-01
Nozzle Sensor Adjustment
SHEET
7/7
5. Remove the nozzle for production
installed on the turret No. 1.
6. Press the SET button again.
The LEDs from NEAR to FAR turn on green.
7. Set the mode set switch to RUN.
8. Check that the L/D set switch is set to
the D side.
9. Close the cover for the sensor.
OUT
SET
NORM
TEACH
RUN
ADJ
ZONE
L
D
NEAR
FAR
L/D set switch
Mode set
switch
SET button
Nozzle
Adjustment
HLGB-10416-01
Adjustment of PWB Sensor
SHEET
1/1
Adjustment of PWB Sensor
This section describes a procedure to adjust sensitivity and installing position of PWB detecting
sensor (BS54, BS50).
[Necessary jigs]
• Do not Use jig.
[Procedure]
1 Remove the upper side panels on both sides
of the unit.
2 Adjust the sensitivity adjustment volume of
the PWB sensors (left side: BS54, right side:
BS50) installed on both ends of the
conveyer to a position of 2/3.
3 Loosen the screw fastening the sensor, and
adjust the sensor position so that the screw
is at the center of the rectangular hole, and
then fasten the screw.
PWB senso
r
Screw
Sensitivity
adjustment volume